ARTÍCULO
TITULO

Model Tests on the Frequency Responses of Offshore Monopiles

Rui He and Tao Zhu    

Resumen

Monopiles are widely used to support offshore wind turbines as a result of the extensive development of offshore wind energy in coastal areas of China. An offshore wind turbine is a typical high-rise structure sensitive to dynamic loads in ocean environment such as winds, water waves, currents and seismic waves. Most of the existing researches focus on elastic vibration analysis, bearing capacity or cyclic degradation problems. There?re very few studies on vibration of monopiles, especially considering the influence of static loads with different amplitudes, directions, and loading-unloading-reloading processes. In this paper, laboratory-scale 1 g model tests for a monopile in dry sands were carried out to investigate the frequency responses of the monopile under different loading conditions. The bearing capacities of the model monopile were obtained as references, and dynamic loads and static loads with different amplitudes were then applied to the monopile. It was found that (1) the first resonant frequency of the monopile decreases with the increase of dynamic load amplitudes; (2) the first resonant frequency of the monopile steadily increases under the lateral static load and loading-unloading-reloading processes; (3) the frequency responses of the monopile with static loads in different directions are also quite different; (4) damping of the monopile is influenced by the load amplitudes, load frequencies, load directions and soil conditions. Besides, all the tests were conducted in both loose sand and dense sand, and the results are almost consistent in general but more obvious in the dense sand case.

 Artículos similares

       
 
Ivan Catipovic, Marta Pedi?ic-Buca and Jo?ko Parunov    
An innovative tourist submarine was studied by scale-model tests in a towing tank to determine its steering capabilities and detect motion instabilities during usual manoeuvres and emergency rising. Motion instabilities are caused by the combination of t... ver más

 
?iga Unuk and Milan Kuhta    
A nonlinear semi-numeric and finite element analysis of three-point bending tests of notched polymer fiber-reinforced concrete prisms was performed. The computational and experimental results were compared in terms of the load-displacement behavior. The ... ver más
Revista: Applied Sciences

 
Zhongchi Liu and C. Guedes Soares    
The volume of a gravity cage is greatly reduced under a current due to the flexible structure, which affects the growth and health of the fish. Thus, an accurate assessment of cage volume is essential to determine the number of fishes in the cage. In thi... ver más

 
Hassan Aleisa, Konstantinos Kontis and Melike Nikbay    
Developing wind tunnel models is time consuming, labor intensive, and expensive. Rapid prototyping for wind tunnel tests is an effective, faster, and cheaper method to obtain aerodynamic performance results while considerably reducing acquisition time an... ver más
Revista: Aerospace

 
Zehua Zhang, Wenle Gao and Yuming Kou    
Micro-parameter calibration is essential in constructing an accurate and reliable numerical model of particle discrete element PFC3D 6.0 software. Micro-parameter calibration is mainly accomplished according to the macro-parameters obtained from static o... ver más
Revista: Applied Sciences