Inicio  /  Applied Sciences  /  Vol: 9 Par: 5 (2019)  /  Artículo
ARTÍCULO
TITULO

High-Sensitive TM Modes in Photonic Crystal Nanobeam Cavity with Horizontal Air Gap for Refractive Index Sensing

Jin-Kyu Yang    
Chae-Young Kim and Minji Lee    

Resumen

We propose a new type of refractive index sensing based on the transverse magnetic (TM) modes in the photonic crystal (PhC) nanobeam (NB) cavity with a horizontal air gap. The electric field of the resonant TM mode is strongly confined within the horizontal air gap present at the PhC NB cavity. In order to increase the quality (Q) factor and the sensitivity (S) of the refractive index change in the air simultaneously, the cavity structure is fully optimized. Because of the trade-off between the Q-factor and S of the TM mode in the PhC NB cavity with an air gap, there is an optimal thickness of the air gap in the dielectric slot. From the numerical simulation results, S can exceed 1000 nm/RIU with Q > 40,000. When the dielectric slot becomes thin, S could be higher than 1200 nm/RIU. For practical applications, we suggest an Si-based PhC NB cavity with a horizontal SiO2 slot structure which can also provide high S with a high Q-factor after a very fine selective wet etching process. This new type of TM resonant mode in the PhC NB cavity can be an ideal platform for compact sensors in photonic integrated circuits for TM waveguide systems.

 Artículos similares

       
 
Anatoly Kalyakin, Alexander Volkov and Liliya Dunyushkina    
An amperometric sensor based on CaZr0.95Sc0.05O3-d (CZS) proton-conducting oxide for the measurement of hydrogen concentration in air was designed and tested. Dense CZS ceramics were fabricated through uniaxial pressing the powder synthesized by the soli... ver más
Revista: ChemEngineering

 
Min-Su Kim, In-Hoi Koo, Keon-Hyeong Lee, Eun-Sung Lee, Hyung-Seok Han, Seung-Min Jeong, Holak Kim and Jeong-Yeol Choi    
This experimental investigation focused on the ignition and combustion characteristics of a tandem cavity-based scramjet combustor with side-by-side identical cavities. This study utilized the Pusan National University-direct connect scramjet combustor (... ver más
Revista: Aerospace

 
Qingcai Zhang, Qinqin Wang, Xiaoming Tan and Jingzhou Zhang    
A rim seal is often used to prevent the ingress of high-temperature gas into the turbine disk cavity and protect the turbine disk from damage. Based on the overlapping rim seal (Seal-A), this paper proposes two more composite sealing structures (Seal-B a... ver más
Revista: Aerospace

 
Zhonghao He, Hongbo Wang, Fan Li, Yifu Tian, Minggang Wan and Jiajian Zhu    
The ethylene-fueled flameholding characteristics of a cavity-based scramjet combustor are experimentally and numerically investigated. The test facility used the air heater, which heats air from room temperature to total temperature 1477 K. A nozzle is i... ver más
Revista: Aerospace

 
Guangyu Wang, Shijie Liu, Haoyang Peng and Weidong Liu    
A continuous detonation engine with various exhaust nozzles, analogous to typical scramjet cavity combustors with variable rear-wall heights, was adopted to perform a succession of cylindrical air-breathing continuous rotating detonation experiments fuel... ver más
Revista: Aerospace