Resumen
In the process of waterflooding development of heavy oil, W/O emulsion has a strong ability to improve the mobility ratio and block the high-permeability layer, which can effectively improve the sweep coefficient and enhance oil recovery. In this paper, the stability and droplet size distribution of emulsions under different conditions were studied by taking heavy oil and formation water from Jimusar Oilfield in Xinjiang as samples. On this basis, double-pipe core flooding experiments were carried out to study the shut-off ability and oil displacement efficiency of W/O emulsion, and then a numerical simulation was carried out. The results show that oil and water can be completely emulsified when the stirring speed is higher than 4000 r/min. A stable emulsion can be formed when the experimental temperature is lower than 60 °C. A lower water cut results in a more stable emulsion. The emulsion is difficult to stabilize after the salinity exceeds 10,000 mg/L. When the pH value is about 7, the stability of the emulsion is the worst. With the increase in stirring speed, the increase in temperature, and the decrease in water content and salinity, the emulsion droplet size range is relatively concentrated, and the average particle size is smaller. In heterogeneous reservoirs, the permeability of different percolation channels is quite different, such that the displacement fluid only percolates along the high-permeability channel and cannot drive oil effectively. The results of displacement experiments show that the emulsion with a water cut of 60% has high viscosity and obvious sweep ability, but its stability is very poor; the effect is opposite when the water cut is less than 40%. The shut-off ability of W/O emulsion disappears gradually when the permeability contrast is more than 5.92. The research results are of great significance for improving oil recovery in heterogeneous heavy oil reservoirs.