ARTÍCULO
TITULO

Influence of New Parameterization Schemes on Arctic Sea Ice Simulation

Yang Lu    
Xiaochun Wang    
Yijun He    
Jiping Liu    
Jiangbo Jin    
Jian Cao    
Juanxiong He    
Yongqiang Yu    
Xin Gao    
Mirong Song and Yiming Zhang    

Resumen

Two coupled climate models that participated in the CMIP6 project (Coupled Model Intercomparison Project Phase 6), the Earth System Model of Chinese Academy of Sciences version 2 (CAS-ESM2-0), and the Nanjing University of Information Science and Technology Earth System Model version 3 (NESM3) were assessed in terms of the impact of four new sea ice parameterization schemes. These four new schemes are related to air?ice heat flux, radiation penetration and absorption, melt ponds, and ice?ocean flux, respectively. To evaluate the effectiveness of these schemes, key sea ice variables with and without these new schemes, such as sea ice concentration (SIC) and sea ice thickness (SIT), were compared against observation and reanalysis products from 1980 to 2014. The simulations followed the design of historical experiments within the CMIP6 framework. The results revealed that both models demonstrated improvements in simulating Arctic SIC and SIT when the new parameterization schemes were implemented. The model bias of SIC in some marginal sea ice zones of the Arctic was reduced, especially during March. The SIT was increased and the transpolar gradient of SIT was reproduced. The changes in spatial patterns of SIC and SIT after adding new schemes bear similarities between the two coupled models. This suggests that the new schemes have the potential for broad application in climate models for simulation and future climate scenario projection, especially for those with underestimated SIT.

 Artículos similares

       
 
Dario Puljic, Asja Celebic, Ines Kovacic and Nikola Petricevic    
The new Ti?Zr (Roxolid®) mini-implants have not yet been fully researched. We analyzed peri-implant and posterior edentulous area microstrains during mandibular overdenture (OD) loading at different sites with different extents of forces when one-, two-,... ver más
Revista: Applied Sciences

 
Xianlong Peng and Yikai Wu    
In order to solve the problems of low efficiency and complex cutting tools in conventional face gear machining, this paper presents a machining method of ruled surface face gears with conical cutters and proposes a new pinion to correct deviation and its... ver más
Revista: Applied Sciences

 
Zitao Du, Wenbo Yang, Yuna Yin, Xinwei Ma and Jiacheng Gong    
When new rail stations or lines are planned, long-term planning for decades to come is required. The short-term passenger flow prediction is no longer of practical significance, as it only takes a few factors that affect passenger flow into consideration... ver más
Revista: Applied Sciences

 
Chen Chen, Hong Zhou, Zhengda Lv and Ziqiu Li    
Plated grillage with combined openings was susceptible to complex failure behaviors as the main load-bearing structure of the superstructure on passenger ships subjected to deck loads. Additionally, the deformation and stresses generated during the weldi... ver más

 
Ligang Yuan, Jing Liu, Haiyan Chen, Daoming Fang and Wenlu Chen    
Scene taxiing time is an important indicator for assessing the operational efficiency of airports as well as green airports, and it is also a fundamental parameter in flight regularity statistics. The accurate prediction of taxiing time can help decision... ver más
Revista: Aerospace