Resumen
The agricultural activity of pruning olive trees generates waste which, due to long-standing practices and unawareness of the consequences, are burned on site, thereby producing CO2 emissions in the atmosphere. Therefore, in order to prevent environmental pollution and a waste of resources, the aim of this research investigation was to highlight some alternative uses of the pruning of olive trees waste. This work focuses on recycled and reused by-products as a secondary raw material for the implementation of interior components that can be used for indoor acoustic correction purposes and evaluates their potential as absorbing materials, without overlooking the aesthetic dimension. In this paper, different configurations based on plywood frames with loose olive pruning chips used as a filler, namely, modules and sub-modules, were investigated. Moreover, other technological details, that is, the influence of a Tissue-Non-Tissue (TNT) layer and a spray film coating applied over the external surface of the loose material, were measured. Sound absorption measurements were conducted inside a small-scale reverberation room (SSRR) and the experimental results demonstrated that the samples, for the given thickness, have weighted sound absorption values (aw) of between 0.15 and 0.35 and single third-octave band values that can reach higher values than 0.50 above 500 Hz. The frequency curves and weighted values of the samples in which the influence of TNT and the spray film coating were tested remained unchanged. This is a design aspect that allows absorbing surfaces to be modeled and integrated with existing walls, while maintaining the acoustic performance and the specific aesthetic features of the loose material.