Inicio  /  Coatings  /  Vol: 11 Par: 5 (2021)  /  Artículo
ARTÍCULO
TITULO

Influence of Rust Inhibitor on the Corrosion Resistance of Reinforcement in Cement Paste with Chloride

Linchun Zhang    
Ailian Zhang    
Ke Li    
Qian Wang    
Junzhe Liu and Hui Wang    

Resumen

The electrical resistance and polarization effect of cement paste containing reinforcement were tested to research the anti-corrosion properties of steel bars in cement paste. Moreover, the microstructure and composition of passivation film and rust on the steel bars were studied. The water?cement ratio of the cement paste in this study was 0.3, with 0.5% NaCl, 1% NaNO2, and 1% Benzotriazole, and an assembly unit of 0.5% NaNO2 + 0.5% Benzotriazole by mass of cement was added to the cement to provide a chloride environment. X-ray photoelectron spectroscopy (XPS) and scanning electron microscope (SEM) were applied to research the composition of the passivation film and the microstructure of the cement paste, respectively. The results indicated that the samples with the assembly unit of 0.5% NaNO2 + 0.5% Benzotriazole showed the highest electrical resistance and polarization electrical resistance, while the specimens with 1.0% Benzotriazole showed the lowest electrical resistance and polarization electrical resistance. Moreover, the passivation film of steel bars weakened with increasing distance from the surface of the steel bars. Therefore, the corrosion of steel bars becomes more serious with increasing distance. Finally, the influence of the rust inhibitor on the corrosion resistance of steel bars in the specimens decreased in the following order: 0.5% NaNO2 + 0.5% Benzotriazole >1.0% NaNO2>1.0% Benzotriazole.

 Artículos similares

       
 
Masood Ur Rahman and Jing Li    
This paper presents experimental investigations on epoxy mortar produced using industrial wastes. In some recent studies, coal bottom ash and polyethylene terephthalate (PET) waste have been chosen as a filler to replace sand, and fly ash and silica fume... ver más
Revista: Applied Sciences

 
Mohsin Iqbal, Saravanan Karuppanan, Veeradasan Perumal, Mark Ovinis and Adnan Rasul    
Exposure to load and offshore environment degrades the load-bearing capacity of tubular joints, necessitating reinforcement of these joints. Reinforcement is sometimes required for lifespan enhancement or qualification based on new requirements. Availabl... ver más

 
Jun-Cheol Lee and Chang-Joon Lee    
The electro-mechanical impedance (EMI) change in Piezoelectric (PZT) sensors embedded in steel-fiber-reinforced mortar (SFRM) was investigated to assess the material setting time. The EMI was continuously monitored for 12 h by the PZT sensor embedded in ... ver más
Revista: Applied Sciences

 
Kwang-Myong Lee, Yong-Sik Yoon, Keun-Hyeok Yang, Bong-Young Yoo and Seung-Jun Kwon    
Concrete structures are considered as durable construction material, but corrosion of the embedded steel reinforcement occurs under chloride exposure as concrete has porous properties. Herein, a cyclic drying?wetting test was performed for two years usin... ver más
Revista: Applied Sciences

 
Vitor A. Nunes, Prannoy Suraneni, Augusto C. S. Bezerra, Carlos Thomas and Paulo H. R. Borges    
Steel slag (SS) is a secondary material from steelmaking production with little commercial value. Its volumetric expansion and low reactivity limit the use of SS in Portland cement (PC)-based materials. This study investigated the potential use of basic ... ver más
Revista: Applied Sciences