ARTÍCULO
TITULO

Experimental study of the accuracy of balancing an axial fan by adjusting the masses and by passive auto-balancers

Irina Filimonikhina    
Yuriy Nevdakha    
Lubov Olijnichenko    
Viktor Pukalov    
Hanna Chornohlazova    

Resumen

The paper reports determining and comparison of the quality of dynamic balancing of rotating parts in the assembly (impeller) by correction mass and applying passive auto-balancers using the axial fan VO 06-300-4 as an example. The impeller is balanced in two planes of correction ? from the side of a fairing and from the side of an electric motor?s shank.It was established that prior to balancing the magnitudes of root-mean-square values (RMS) of vibration speed at the casing of the fan correspond with a margin to the balance quality grade: 1x vibration components (1x) ? G2.5; total ? G6.3. The main source of vibrations is the dynamic residual imbalance of the impeller. The basic component of vibration speeds is the 1x one (at a frequency of 25 Hz), that is, it can be reduced by balancing. The non-1x vibration components occur at subharmonic frequencies, 25/2 and 25/3 Hz, and are smaller by the order of magnitude.When the impeller is balanced by correction mass, the initial imbalances from the side of a fairing and a shank are, respectively, 81.4 and 115.2 g·mm, and the residual ones are 7.4 and 7.2 g·mm. The magnitudes of RMS of vibration speed can be reduced at the fan?s casing to the magnitudes corresponding to the balance quality grade (with a margin): 1x ? G0.4; total ? G2.5. The main contribution to the residual vibrations is made by the non-1x vibration components occurring at subharmonic frequencies.At dynamic balancing of the impeller by two ball auto-balancers, in the presence of any imbalances (in two planes of correction) that can balance the auto-balancers, the RMS of vibration speed at the fan?s casing correspond to the balance quality grade: 1x ? G1; total ? G2.5. Ball auto-balancers react to imbalances constituting not less than 3 % of their balancing capacity. The residual imbalances are not stable, but are not larger from the side of a fairing and a shank than, respectively, 22.2 g·mm and 21.6 g·mm.Research results are applicable for low-pressure axial fans, specifically VO 06-300/VO-12-300; VOG/VO-15-320; VO 2,3-130/VO 46-130. They make it possible to decide on the expediency of balancing fans by passive auto-balancers

 Artículos similares

       
 
Zhike Zou, Longcang Shu, Xing Min and Esther Chifuniro Mabedi    
The artificial recharge of stormwater is an effective approach for replenishing aquifer and reduce urban waterlogging, but prone to clogging by suspended particles (SP) that are highly heterogeneously sized. In this paper, the transport and deposition of... ver más
Revista: Water

 
Zuhier Alakayleh, Xing Fang and T. Prabhakar Clement    
This study aims at furthering our understanding of the Modified Philip?Dunne Infiltrometer (MPDI), which is used to determine the saturated hydraulic conductivity Ks and the Green?Ampt suction head ? at the wetting front. We have developed a forward-mode... ver más
Revista: Water

 
Ewa Stanczyk-Mazanek, Longina Stepniak and Urszula Kepa    
In this paper, we discuss the effect sewage sludge (SS) application has on the contamination of polycyclic aromatic hydrocarbons in fertilized soils and groundwater. Morver, the contents of these compounds in plant biomass was analyzed. For six months, c... ver más
Revista: Water

 
Xiaoni Yang, Juanjuan Ma, Yongye Li, Xihuan Sun, Xiaomeng Jia and Yonggang Li    
Hydraulic transportation of the piped carriage is a new energy-saving and environmentally-friendly transportation mode. There are two main states in the conveying process, stationary and moving. In the process of hydraulic transportation of the piped car... ver más
Revista: Water

 
Taufiq Saidi,Taufiq Saidi,Muttaqin Hasan,Muttaqin Hasan,Zahra Amalia,Muhammad Iqbal,Muhammad Iqbal     Pág. 155 - 164
The use of synthetic Fiber Reinforced Polymer (FRP) as a composite material is an alternative material that has been widely used for strengthening and repairing reinforced concrete structures. However, the high price is one of the obstacles in applying s... ver más