ARTÍCULO
TITULO

Structural features and inactivation of coagulation proteases of a sulfated polysaccharidic fraction from Caulerpa cupressoides var. lycopodium (Caulerpaceae, Chlorophyta) - doi: 10.4025/actascitechnol.v35i4.16709

José Ariévilo Gurgel Rodrigues    
Érico Moura Neto    
Lisandra Antônia Castro Teixeira    
Regina Célia Monteiro de Paula    
Paulo Antônio de Souza Mourão    
Norma Maria Barros Benevides    

Resumen

Studies on biopolymers from macroalgae suggested sulfated polysaccharides (SPs) as research agents to investigate events related to haemostasis. Caulerpa cupressoides var. lycopodium is a marine green alga containing three SPs fractions (SP1, SP2 and SP3). SP2 had anticoagulant (in vitro) and anti- and prothrombotic (in vivo) actions; however, its effect on the coagulation system is not fully understood. This study aimed to determine the infrared (IR) spectroscopy, chemical composition (CC), elemental microanalysis (EM), molecular weight (MW) and the effect on coagulation proteases of SP2. The presence of sulfate ester, galactose-6-sulfate, uronic acid and glycoside linkages for IR spectrum; contents of sulfate (28%), total sugars (40%) and uronic acids (7.18%) for CC; and content of carbon (21.98%), sulfate (4.27%), nitrogen (1.3%) and hydrogen (4.86%) for EM were obtained. The average molecular weights of four different SPs (SP-1, SP-2, SP-3 and SP-4) subfractions from the SP2 ranged from ~ 8 to >100 kDa. SP2 was tested on coagulation proteases (thrombin and factor Xa) in the presence of antithrombin (AT) and heparin cofactor II (HCII) using human plasma, being both thrombin and factor Xa target proteases inhibited, but requiring a concentration of about 2.5-fold higher of HCII than the thrombin inactivation by AT.   

 Artículos similares

       
 
Leonid Dvorkin, Vitaliy Marchuk, Katarzyna Mróz, Marcin Maroszek and Izabela Hager    
Compositions of fine-grained concrete mixtures that provide the minimum required strength values in 1 day (7.5 MPa) have been developed. A comparison was made of the test results of the properties of samples printed on a 3D printer with samples made acco... ver más
Revista: Applied Sciences

 
Ioannis Karampinis, Lazaros Iliadis and Athanasios Karabinis    
Structures inevitably suffer damage after an earthquake, with severity ranging from minimal damage of nonstructural elements to partial or even total collapse, possibly with loss of human lives. Thus, it is essential for engineers to understand the cruci... ver más
Revista: Applied Sciences

 
Stefan Peev, Ivaylo Parushev and Ralitsa Yotsova    
Undecalcified bone histology is a valuable diagnostic method for studying bone microarchitecture and provides information on bone formation, resorption, and turnover. It has various clinical and research applications. Toluidine blue has been widely adopt... ver más
Revista: Applied Sciences

 
Bora Pulatsu, Rhea Wilson, Jose V. Lemos and Neboj?a Mojsilovic    
Unreinforced masonry (URM) walls are common load-bearing structural elements in most existing buildings, consisting of masonry units (bricks) and mortar joints. They indicate a highly nonlinear and complex behaviour when subjected to combined compression... ver más
Revista: Infrastructures

 
Domenik Radeck, Felix He-Mao Hsu, Florian Janke, Gabriele Semino, Tim Hofmann, Sebastian Rink and Agnes Jocher    
The hyperloop concept envisions a low pressure tube and capsules, called pods, traveling at the speed of commercial aircraft as a sustainable, future-proof mass transportation system between cities. However, in contrast to the use case of such a system, ... ver más