ARTÍCULO
TITULO

Determination of mechanical properties of fibers of Bambusa Vulgaris to use in bamboo mat board

Lena Mora Rodríguez    
Emilio Álvarez García    
Jorge Hernández González    

Resumen

At the present time a world tendency exists to the use of the natural fibers as reinforcement material in composite materials. In such a sense presently work you to carry out an analogical and experimental analysis to determine the behaviour of the mechanical properties of the bamboo fibers and in specific the resistance to the rupture, the module of Elasticity and the poisson coefficient. Moreover, it is evaluate the influence of the temperature, the pressure and the time on the percent of humidity lost and about the thickness of the bamboo mat board. Finally one has that for their properties and characteristic the bamboo fiber is a natural fiber that may be an employee as reinforcement in Composite materials.Rev. ing. constr. [online]. 2009, vol.24, n.2, pp. 153-166. ISSN 0718-5073.  http://dx.doi.org/10.4067/S0718-50732009000200003

 Artículos similares

       
 
Run Zhou, Jingyan Jiang, Jianhua Qin, Ning Du, Haoran Shi and Ying Wang    
The corrugated compensators are important components in the piping system, absorbing mechanical deformation flexibly. To reduce the risk of the piping system with corrugated compensators and improve the safety and stability of industrial equipment, condi... ver más
Revista: Applied Sciences

 
Brendan C. O?Kelly, Jacinto Alonso-Azcárate and José Manuel Moreno-Maroto    
The remolding toughness property of fine-grained soil has not been investigated that much, mainly because it has not lent easily to direct measurement, with soil toughness usually qualitatively described. In practical terms, as the plastic limit wP is ap... ver más
Revista: Applied Sciences

 
Song Li, Xingxing Shi, Chundi Si, Binshuo Bao and Mengmeng Hu    
The performance of an asphalt mixture is significantly affected by the properties of its asphalt mortar, which consists of an asphalt binder, mineral fillers, fine aggregates and air voids. The aim of this work was to evaluate the correlations between th... ver más
Revista: Coatings

 
Timothy Devenport, Bernard Rolfe, Michael Pereira and James M. Griffin    
In this paper, the applicability of acoustic emission (AE) measurement of galling wear in sheet metal forming (SMF) is investigated.
Revista: Applied Sciences

 
Joseph Dei Rossi, Ozgur Keles and Vimal Viswanathan    
The recent development of RepRap style 3D printers has made additive manufacturing technology available to the public at a low cost. While these 3D printers are being used for a variety of purposes, one of the main applications is prototyping in design p... ver más
Revista: Applied Sciences