|
|
|
Mara Kandeva, Mihail Zagorski, Ru?ica Nikolic, Bla?a Stojanovic, Adrian But, Franti?ek Botko, Ján Pitel and Aleksandar Vencl
The nickel (Ni) coatings without and with embedded (5?7 vol. %) cubic boron nitride (c-BN) nanoparticles (10 nm in diameter) were deposited on carbon steel substrate by an electroless plating process. Coatings were tested in as-deposited and heat-treated...
ver más
|
|
|
|
|
|
Shuyuan Xu, Jun Wang, Peng Wu, Wenchi Shou, Xiangyu Wang and Mengcheng Chen
Pavement markings constitute an effective way of conveying regulations and guidance to drivers. They constitute the most fundamental way to communicate with road users, thus, greatly contributing to ensuring safety and order on roads. However, due to the...
ver más
|
|
|
|
|
|
Luis Domenech, Víctor García-Peñas, Asta ?akalyte, Divya Puthukara Francis, Eskil Skoglund and Fernando Sánchez
Under droplet impingement, surface leading edge protection (LEP) coating materials for wind turbine blades develop high-rate transient pressure build-up and a subsequent relaxation in a range of strain rates. The stress-strain coating LEP behavior at a w...
ver más
|
|
|
|
|
|
Bojan Pajic, Pavel Zakharov, Brigitte Pajic-Eggspuehler and Zeljka Cvejic
A prospective feasibility study was conducted to determine whether a new wearable device, the Visual Behavior Monitor (VBM), was easy to use and did not present any difficulties with the daily activities of patients. Patients for cataract surgery and ref...
ver más
|
|
|
|
|
|
Shinichiro Adachi and Nobuhiro Ueda
Cold-sprayed AISI 316L stainless steel coatings are treated to form an austenite phase with excessive dissolved nitrogen (known as the S-phase) by plasma nitriding at temperatures below 450 °C. The S-phase is a hard and wear-resistant layer with high cor...
ver más
|
|
|