|
|
|
|
|
Wooseok Jeong, Seungeon Jang and Hong-Jip Kim
Since a heat exchanger used in a gas generator of an open-cycle liquid rocket engine was operated in a high-temperature environment, the coupled analysis for heat transfer characteristics and structural integrity should be performed simultaneously. For t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Christopher Hartmann, Julia Schweikert, François Cottier, Ute Israel, Jochen Gier and Jens von Wolfersdorf
Experimental results for the transient heat transfer characteristics over a flat plate and over a plate with V-shaped ribs were compared to numerical results from a coupling environment applying FEM and CFD. In order to simulate transient effects in the ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jacqueline Hannss, Jeremias Grün, Christoph Olbrich, Simon Feldmeth and Frank Bauer
Rotary shaft seals prevent the exchange of fluid at shaft passages. Their function and service life depend decisively on the temperature in the contact area between the sealing edge and the shaft. Since the temperature depends on both the generation of f...
ver más
|
|
|
|
|
|
|
|
|
|
|
E. S. Abdelghany, Mohamed B. Farghaly, Mishari Metab Almalki, H. H. Sarhan and Mohamed El-Sayed M. Essa
Airplane manufacturers are frequently faced with formidable challenges to improving both aircraft performance and customer safety. Ice accumulation on the wings of aircraft is one of the challenges, which could result in major accidents and a reduction i...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhe Zhang, Zeyu Wu, Xiang Luo and Weitong Liu
The traditional blade cooling method can no longer meet the requirements of high cooling efficiency in modern engines. In order to solve this cooling problem, this paper proposes cooling turbine guide blades based on liquid metal. The feasibility was pre...
ver más
|
|
|
|
|
|
|
|
|
|
|
Banghua Zhao, Sujun Dong, Chen Ding and Zhiliang Cui
The present study proposes a novel optimization strategy (NOS) for quasi-steady algorithms to optimize the initial error in the fast calculation of conjugate heat transfer (CHT) simulations. In this approach, the change in Nusselt number at the fluid?sol...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jeongmoo Huh and Ki Sun Park
This paper reports on the effect of structural materials on heat loss-associated propulsion performance degradation of monopropellant thrusters in the micro scale. In order to address the effect of fabrication materials on heat loss, propellant flow char...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ali Habeeb Askar, Endre Kovács and Betti Bolló
This study aimed to estimate the heating load (HL) and the cooling load (CL) of a residential building using neural networks and to simulate the thermal behavior of a four-layered wall with different orientations. The neural network models were developed...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qinghua Deng, Huihui Wang, Wei He and Zhenping Feng
The leading edge is the critical portion for a gas turbine blade and is often insufficiently cooled due to the adverse effect of Crossflow in the cooling chamber. A novel internal cooling structure, wall jet cooling, can suppress Crossflow effect by chan...
ver más
|
|
|
|
|
|
|
|
|
|
|
Mustafa Alaskari, Arwa M. Kadhim, Ammar A. Farhan, Moustafa Al-Damook and Mansour Al Qubeissi
Artificial roughness applied to a Solar Air Heater (SAH) absorber plate is a popular technique for increasing its total thermal efficiency (????-??h
?
t
-
t
h
). In this paper, the influence of geometrical parameters of V-down ribs attached below the cor...
ver más
|
|
|
|
|
|