48   Artículos

 
en línea
Piero Colajanni, Lidia La Mendola, Alessia Monaco and Salvatore Pagnotta    
Seismic-resilient buildings are increasingly designed following low-damage and free-from-damage design strategies that aim to protect the structure?s primary load-bearing systems under ultimate-level seismic loads. With this scope, damping devices are lo... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Katharina Brinkmann, Thomas Hoffmann, Lars Panning-von Scheidt and Heinrich Stüer    
In this work, the vibration response of an academic free-standing turbine blisk is analyzed in regard to transient resonance passages. Measurement data are recorded using strain gauges and tip timing to evaluate the blades first bending mode both linearl... ver más

 
en línea
Giuseppe Pezzinga    
Water hammer flow is examined, putting into evidence that unsteady friction cannot be fully responsible for observed oscillation damping. The measured piezometric head oscillations of water hammer flow experimental tests carried out for very long time (a... ver más
Revista: Water    Formato: Electrónico

 
en línea
Xueyuan Yan, Yongtai Yang, Tonghan Guo, Guoguan Lan and Huimin Mao    
In order to improve the seismic and energy dissipation capacity of the whole structure, a friction-oval section mild steel rod composite damper (FOSRCD) was proposed, and its working principle was clarified. The finite element analysis of FOSRCD was carr... ver más
Revista: Buildings    Formato: Electrónico

 
en línea
Yanan Wu, Haijun Xuan, Changyao Wu, Dong Mi, Mingmin Qu and Tao Jin    
Underplatform dampers (UPDs), a type of dry friction damper, are commonly used for vibration reduction of turbine blades. This study investigated the effect of UPDs on the forced torsional vibration response of turbine blades within a multi-blade system.... ver más
Revista: Aerospace    Formato: Electrónico

 
en línea
Xiaojie Jiao, Cheng Cheng, Yubing Song, Gang Wang and Linjuan He    
The rock deformation and failure characteristics and mechanisms are very important for stability evaluation and hazard control in rock engineering. The process of rock deformation and failure is often accompanied by temperature changes. It is of great si... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Hitoshi Tanaka, Nguyen Xuan Tinh and Ahmad Sana    
According to recent investigations on bottom boundary layer development under tsunami, a wave boundary can be observed even at the water depth of 10 m, rather than a steady flow type boundary layer. Moreover, it has been surprisingly reported that the ts... ver más
Revista: Journal of Marine Science and Engineering    Formato: Electrónico

 
en línea
Ganbo Zhang, Yao Zhao and Wei Chu    
Propeller-induced longitudinal vibration resonance in marine propulsion shafting systems causes great harm to the hull structure and is the primary source of shipboard noise. Integrating a friction damper with designed parameters into thrust bearings can... ver más
Revista: Journal of Marine Science and Engineering    Formato: Electrónico

 
en línea
Xinyi Yuan, Yan Su and Peng Xie    
The frequency characteristics of free surface elevation time histories of shallow-water sloshing in a three-dimensional rectangular tank is presented. The numerical model for sloshing motion uses an accurate velocity potential Boussinesq-type equation. A... ver más
Revista: Journal of Marine Science and Engineering    Formato: Electrónico

 
en línea
Shuang Wu, Zhijun Zhao, Dongping Liang, Qunzhi Li and Shougen Zhao    
Multiple linear and nonlinear dynamic parameters of the joints at the root of solar panels and between solar panels on spacecraft, both of which have complex nonlinear dynamic properties, were identified by using the force state mapping method for modeli... ver más
Revista: Aerospace    Formato: Electrónico

« Anterior     Página: 1 de 3     Siguiente »