|
|
|
Xuewen Fu, Ximei Wei, Meng Wang, Hongwen Zhang, Lei Wang, Jun Wang and Yuanzhao Zheng
This study investigated the impact of compression molding parameters on the post-molding characteristics of machine-harvested seed cotton and aimed to determine the optimal compression molding parameters. The closed compression test of seed cotton and fo...
ver más
|
|
|
|
|
|
|
Junhan Lee, Jongsun Kim and Jongsu Kim
|
|
|
|
|
|
|
Xishuang Jing, Siyu Chen, Jiuzhi An, Chengyang Zhang and Fubao Xie
This study was to solve the mandrel demolding problem after curing the composite component with complex structure. In this paper, a reusable thermoplastic mandrel with heating softening characteristics was developed by resin transfer molding (RTM). The g...
ver más
|
|
|
|
|
|
|
Mihailo Kravchenko,Larysa Rybchuk,Dina Fedorova,Roman Romanenko,Vladimir Piddubnyi,Inna Danyliuk,Karina Palamarek,Tatiana Marusyak,Tetiana Nezveshchuk-Kohut
Pág. 22 - 33
Results obtained in the studies of rheological, surface and sensory characteristics of marzipan paste containing dry demineralized whey (DDW) are presented in this paper. Positive effect of DDW on sensory characteristics of model compositions of marzipan...
ver más
|
|
|
|
|
|
|
Tzu-Hsia Chen, Long-Chang Hsieh
Pág. 33 - 44
Blow-molding machines are divided into two types: (1) rotary type blow-molding machine, and (2) linear type blow-molding machine. Good kinematic characteristics of mold clamping mechanism is the goal pursued by manufacturers of blow-molding machine. Trad...
ver más
|
|
|
|
|
|
|
Min-Wen Wang, Fatahul Arifin, Van-Hanh Vu
Pág. 278 - 294
Injection molding technology is known as the most widely used method in mass production of plastic products. To meet the quality requirements, a lot of methods were applied in optimization of injection molding process parameter. In this study the optimiz...
ver más
|
|
|
|
|
|
|
Li-Chun Chang, Yu-Zhe Zheng, Yung-I Chen, Shan-Chun Chang and Bo-Wei Liu
High-Si-content transition metal nitride coatings, which exhibited an X-ray amorphous phase, were proposed as protective coatings on glass molding dies. In a previous study, the Zr–Si–N coatings with Si contents of 24–30 at.% exhibited ...
ver más
|
|
|
|
|
|
|
Erika Fekete, Dávid Kun, János Móczó
Pág. 129 - 136
hermoplastic starch (TPS)/wood composites in a wide composition range were prepared in an internal mixer followed by compression molding. Three types of lignocellulose fibers were used to study the effect of particle and surface characteristics on the pr...
ver más
|
|
|
|
|
|
|
P. G. Anofriev
Pág. 124 - 135
|
|
|
|
|
|
|
Agus Setyo Muntohar
Pág. pp. 1 - 5
The strength gain of stabilized soils is not only influenced by the type and proportion of the stabilizers and its curing time, but also by the water content needed to maintain the reaction. The reaction of lime ? RHA with soil is pozzolanic. Hence, the ...
ver más
|
|
|
|