|
|
|
|
|
Ruilin Liu, Yunqi Liu, Hongming Liu, Yuanxing Li, Hui Chen and Zongtao Zhu
Laser?MIG hybrid welding?brazing was used to weld 304 stainless steel and 6061-T6 aluminum alloy with a thickness of 2 mm. The microstructure, morphology, chemical composition and corrosion behavior of the samples after high-temperature oxidation were in...
ver más
|
|
|
|
|
|
|
|
|
|
|
Bhabani Bora, Ratnesh Kumar, Somnath Chattopadhyaya and Sebastian Borucki
In this investigation, dissimilar material AA6061-T6 and Cu B370 were joined by friction stir welding (FSW). This paper presents a feasibility study of FSW to join Al-alloy and Cu-alloy. The experiment was conducted using general full factorial design by...
ver más
|
|
|
|
|
|
|
|
|
|
|
Darmadi B. Djarot, Femiana Gapsari, Osmar Buntu Lobo and Firman Mangasa Simanjuntak
Stress corrosion cracking (SCC) is known as a major factor that should be considered in the assessment of welding joint structure integrity. Despite the promising and wide application of dissimilar metal joints, the currently available SCC mitigation tec...
ver más
|
|
|
|
|
|
|
|
|
|
|
Totok Suwanda,Rudy Soenoko,Yudy Surya Irawan,Moch Agus Choiron
Pág. 38 - 43
In the previous study, Continuous Drive Friction Welding (CDFW) had been investigated to determine the strength of joining, burn off, and temperature distribution. In this study, Dissimilar Metal CDFW was studied to assess temperature cycle analysis. Alu...
ver más
|
|
|
|
|
|
|
|
|
|
|
Dong-Hyuck Kam, Nam-Ki Jeon, Taek-Eon Jeong and Jedo Kim
In this study, we present improved fusion-bonding strength results between carbon fiber-reinforced polyetheretherketone (CFR-PEEK) and zinc-coated steel through the introduction of pre-inscribed laser surface patterns. Optimized laser welding parameters,...
ver más
|
|
|
|
|
|
|
|
|
|
|
S. P. Sundar Singh Sivam, Krishnaswamy Saravanan, Nagaraj Pradeep, Karuppiah Sathiya Moorthy, Sankarapandian Rajendrakumar
Pág. 277 - 283
The welding of Magnesium and Titanium and its alloys has continuously depicted a good challenge for designers and technologists. Ti and Mg alloys, particularly heat-treatable alloys, are difficult to join by fusion fastening techniques. The welding of di...
ver más
|
|
|
|
|
|
|
|
|
|
|
Gurunath Shinde,Prakash Dabeer
Pág. 373 - 384
Friction welding is a solid state welding processes in which the weld is obtained by the heat generated due to forging and friction. Now a day?s eco-friendly joining of dissimilar materials is the need of the industries. The advantages of friction weldin...
ver más
|
|
|
|
|
|