|
|
|
|
|
Muhammad Azam Saeed, Lukasz Niedzwiecki, Muhammad Yousaf Arshad, Jan Skrinsky, Gordon E. Andrews and Herodotos N. Phylaktou
Design of explosion safety measures for torrefaction installations and design of pulverized-fired burners for biocoal.
|
|
|
|
|
|
|
|
|
|
|
Maija Kymäläinen, Jakub Dömény and Lauri Rautkari
Surface carbonization, or charring, of wooden cladding boards is a promising, low impact process that can substitute inorganic coatings. The char surface is inert and hydrophobic and possibly a long-lasting solution for exterior uses. To determine the pe...
ver más
|
|
|
|
|
|
|
|
|
|
|
Tatjana Paulauskiene, Jochen Uebe, Zilvinas Kryzevicius, Valeriia Kaskova, Marija Katarzyte and Donata Overlinge
Crude oil and petroleum products made from it are increasingly being extracted and consumed worldwide as an important energy source. During necessary transportation, e.g., by tanker, an oil spill might occur, which leads to water pollution by oil. One of...
ver más
|
|
|
|
|
|
|
|
|
|
|
Joran van Blokland, Stergios Adamopoulos and Sheikh Ali Ahmed
Previous studies have shown that thermally modified wood (TMW) performs well in outdoor, above-ground conditions in terms of resistance to wood-decaying fungi. Yet, little is known about the development of defects such as checks and the corresponding mec...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jing-Wen Zhang, Hong-Hai Liu, Lin Yang, Tian-Qi Han and Qin Yin
Thermal modification (TM) improves the hydrophobicity, dimensional stability, and durability of wood, but TM commonly results in severe color change and mechanical strength loss as wood is treated at higher temperature. In this study, Pterocarpus macroca...
ver más
|
|
|
|
|
|
|
|
|
|
|
João C. Costa,Jorge M. Branco,Aires F. Camões
Pág. 488 - 500
The thermal modification has proved to be an effective method to improve the durability of wood elements. Until now, most applications of thermally modified wood have been limited to non-structural applications since the wood?s heat treatment leads to a ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yalun Shen, Yitian Wu, Zhehong Shen and Hao Chen
Self-healing superhydrophobic surfaces have been fabricated by casting and drying water-soluble amphiphilic polymer suspensions at room temperature through thermal reconstruction. When compared with previous methods, this approach exploits modified natur...
ver más
|
|
|
|
|
|
|
|
|
|
|
Milo? Pánek, Eli?ka Oberhofnerová, Ale? Zeidler and Premysl ?edivka
The durability of transparent coatings applied to an oak wood exterior is relatively low due to its anatomic structure and chemical composition. Enhancement of the protection of oak wood against weathering using transparent hydrophobic coatings is presen...
ver más
|
|
|
|
|
|
|
|
|
|
|
Laura A. Schifman, Varun K. Kasaraneni, Ryan K. Sullivan, Vinka Oyanedel-Craver, Thomas B. Boving
Pág. 1 - 16
Non-point source pollution of stormwater contributes high contaminant loads into surface water bodies and poses a threat to the ecosystem, public health and economy. Although (pre)treatment standards have not been introduced at the federal level, Rhode I...
ver más
|
|
|
|
|
|
|
|
|
|
|
Philip D. Evans, Stephan Vollmer, Joseph Doh Wook Kim, George Chan and Sara Kraushaar Gibson
Remarkable increases in the performance of complex systems can be achieved by a collective approach to optimizing individual factors that influence performance. This approach, termed the aggregation of marginal gains, is tested here as a means of improvi...
ver más
|
|
|
|
|
|