|
|
|
|
|
Liutauras Marcinauskas, ?ydrunas Kavaliauskas, Kamile Jonynaite, Rolandas Uscila, Mindaugas Aikas, Skirmantas Ker?ulis, Antanas Strak?ys, Arunas Stirke and Voitech Stankevic
A gliding arc discharge (GAD) plasma device has been developed and tested. Possible applications areas for GAD plasma could be microalgae suspension treatments and the creation of plasma-activated water. To understand its behavior, the influence of the i...
ver más
|
|
|
|
|
|
|
|
|
|
|
Lakshmi Narayana Phaneendra Peri, Antonella Ingenito and Paolo Teofilatto
The goal of this paper is to investigate the aerodynamic and aerothermodynamic behavior of the Schiaparelli capsule after the deployment of a supersonic disk-gap-band (DGB) parachute during its re-entry phase into the Martian atmosphere. The novelty of t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Agnieszka Starek-Wójcicka, Agnieszka Sagan, Piotr Terebun, Michal Kwiatkowski, Emilia Osmólska, Marta Krajewska, Elzbieta Grzadka, Narumol Matsuyama, Nobuya Hayashi and Joanna Pawlat
This paper presents the results of an experiment based on using a Glide-arc type plasma reactor operating at atmospheric pressure for the quality of fresh pressed tomato juice, variety Bekas. The impact of after-glow plasma gas (air) on the physicochemic...
ver más
|
|
|
|
|
|
|
|
|
|
|
Rubing Liu, Shenghui Xue, Wentao Wei, Qi Lin and Kun Tang
Conventional plasma synthetic jet actuators rely only on jet orifice for suction when functioning for long durations. A limited supplementary gas leads to jet velocity reduction and weakening of the flow control ability. Therefore, this study proposes an...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhengqi Tai, Qian Chen, Xiaofei Niu, Zhenhua Lin and Hesen Yang
In order to explore plasma-assisted turbulent mixing in aerospace engines, the dielectric barrier discharge plasma actuation for the turbulent mixing of fuel droplets and oxidant air in a ramjet combustor was studied using computational fluid dynamics. A...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ghazanfar Mehdi, Maria Grazia De Giorgi, Sara Bonuso, Zubair Ali Shah, Giacomo Cinieri and Antonio Ficarella
This study investigates the kinetic modeling of CH4/H2/Air mixture with nanosecond pulse discharge (NSPD) by varying H2/CH4 ratios from 0 to 20% at ambient pressure and temperature. A validated version of the plasma and chemical kinetic mechanisms was us...
ver más
|
|
|
|
|
|
|
|
|
|
|
Riccardo Nicolaidis, Francesco Nozzoli, Giancarlo Pepponi and on behalf of the NUSES Collaboration
NUSES is a planned space mission aiming to test new observational and technological approaches related to the study of relatively low-energy cosmic rays, gamma rays, and high-energy astrophysical neutrinos. Two scientific payloads will be hosted onboard ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Amrinder Mehta, Hitesh Vasudev, Sharanjit Singh, Chander Prakash, Kuldeep K. Saxena, Emanoil Linul, Dharam Buddhi and Jinyang Xu
Thermal barrier coating is critical for thermal insulation technology, making the underlying base metal capable of operating at a melting temperature of 1150 °C. By increasing the temperature of incoming gases, engineers can improve the thermal and mecha...
ver más
|
|
|
|
|
|
|
|
|
|
|
Szymon Kowalski, Weronika Gonciarz, Radoslaw Belka, Anna Góral, Magdalena Chmiela, Lukasz Lechowicz, Wieslaw Kaca and Wojciech Zórawski
Air plasma spraying (APS) is a common method of producing hydroxyapatite (HA) coatings for alloprosthetic implants. Modification of HA spraying potentially may diminish the risk of inflammation and local infection during bone implantation. Titanium impla...
ver más
|
|
|
|
|
|
|
|
|
|
|
Airingas ?uopys, Viktorija Grigaitiene, Liutauras Marcinauskas, Romualdas Ke?elis, Rolandas Uscila and Mindaugas Aikas
In this study, alumina coatings were formed using atmospheric plasma spraying, increasing the torch power from 29.4 to 45.1 kW. The surface morphology of the coatings was determined using scanning electron microscopy; the elemental composition was examin...
ver más
|
|
|
|
|
|