Resumen
Forty-eight water samples (30 groundwater and 18 surface water samples) were collected from the study region. Physical and chemical examinations were performed on the water samples to determine the values of various variables. Several graphs, sheets, and statistical measures, including the sodium solubility percentage (SSP), the sodium absorption ratio (SAR), and Piper?s diagram, were used to plot the concentration of the principal ions and the chloride mass balance (CMB). The contents of the variables were compared with the contents in other local areas and the standard allowable safe limits as recommended by the World Health Organization (WHO). Water pH values were neutral for all water samples. Electric conductivity (EC) readings revealed that water samples vacillated from slightly mineralized to excessively mineralized. Water salinities were fresh and very fresh according to the total dissolved solids (TDS) amounts. The hardness of water ranged from medium to hard in the surface water and from medium to very hard in the groundwater samples. Bicarbonate, sodium, and calcium made up the highest amounts in the surface water samples. The highest concentrations of bicarbonate, sulfate, chloride, and sodium were found in the groundwater. Diagrams show the major ion relationships as well as the type and origin of the water. According to Piper?s plots, most of the water samples under investigation were Ca-HCO3 type, Mg water types, followed by SO4.Ca-Cl water types. This highlighted the elemental preponderance of bicarbonate and alkaline earth (Ca2+ + Mg2+). This dominance is caused by evaporite and carbonate minerals dissolving in water because of anthropogenic activities and interaction processes. The groundwater recharge was estimated to be 0.89?1.6 mm/yr based on Chloride Mass Balance. The examined water samples can also be used for cattle, poultry, and irrigation. Additionally, the groundwater is of poorer quality than the surface water, although both types of water are adequate for various industries, with a range of 14 to 94 percent. With the exception of a few groundwater samples, the tested water samples are suitable for a number of applications.