ARTÍCULO
TITULO

Numerical Simulation of Hydrate Dissociation Behaviors in Hydrate Reservoir with Different Properties during Horizontal Well Drilling

Fei Gao    
Yu Zhang    
Chang Chen    
Xiaosen Li and Zhaoyang Chen    

Resumen

The effectiveness of horizontal well drilling in improving the gas recovery efficiency of hydrate production makes it a promising technology for commercial exploitation. However, during horizontal well drilling in hydrate reservoirs, it is crucial to control hydrate dissociation to ensure the reservoir stability and drilling safety. In this work, a two-dimensional model using polar coordinates was built to study the influences of hydrate reservoir characteristics and drilling fluid salinity on gas production. The simulation applies to the hydrate reservoir of the second natural gas hydrate (NGH) production test in the Shenhu area of the South China Sea. The characteristics of hydrate dissociation and secondary formation and the drilling invasion behavior in the NGH layer and the mixing layer (free gas + hydrate) during horizontal well drilling were analyzed and compared. The simulation results indicated that the pressure and temperature transmission rates in the mixing layer (free gas + hydrate) are higher than those in the NGH layer. The invasion amount of drilling fluid in the mixing layer is 18.8 times more than that in the NGH layer. Under the high invasion of the drilling fluid, the hydrate dissociation amount in the mixing layer is similar to that of the NGH layer even though the initial hydrate saturation of the NGH layer was 2.65 times that of the mixing layer. The area of the hydrate dissociation in the mixing layer is much larger than that in the NGH layer, which may lead to the increase in risk of wellbore instability. The secondary hydrate formation is only observed in the NGH layer, which inhibits the drilling fluid invasion. The salinity of the drilling fluid has a more significant impact on the hydrate dissociation near the wellbore in the mixing layer compared to the NGH layer. With the increase in salinity from 3.05 wt% to 20 wt%, the hydrate dissociation range in the mixing layer increases from 0.16 m to 0.23 m, while the hydrate dissociation range in the NGH layer does not significantly change.

 Artículos similares

       
 
Yue Qiu, Xiangfu Wang, Zhaofeng Wang, Wei Liang and Tongbin Zhao    
In order to study the influence of damage on the gas production of natural gas hydrate, a multi-physical field theoretical model considering damage effect and coupling thermal-hydraulic-mechanical-chemical (THMC) was established by theoretical analysis a... ver más

 
Jiyan Qiao, Xiaobing Lu and Xuhui Zhang    
A separate-bottom Couette cell is used to carry out ring-shear tests on sand and hydrate, and the evolution of shear bands is recognized using the tracer method. Based on experimental verification, a numerical simulation method is applied to study the sh... ver más

 
Yaobin Li, Xin Xin, Tianfu Xu, Huixing Zhu, Haibin Wang, Qiang Chen and Bo Yang    
Gas hydrates are likely to become an important strategic resource with commercial development prospects. It is therefore of great significance to realize the long-term and efficient production of methane hydrate reservoirs. Previous studies have shown th... ver más

 
Xuyang Guo, Yan Jin, Jingyu Zi, Jiaying Lin, Bolong Zhu, Qian Wen and Qi Jing    
Sand production has been identified as a key reason limiting sustained and commercial gas production in methane-hydrate-bearing sediments. Production tests in Canada and Japan were terminated partially because of excessive sand production in pilot wells.... ver más

 
Gang Li, Fugui Tang, Chaofan Li, Wen Lei and Ying Liu    
Gas hydrate is seen as a kind of new energy resources, yet it may also be one of the main greenhouse gases as its dissociation may release methane into the atmosphere. Furthermore, a severe hazard to offshore infrastructures may also be introduced by ext... ver más