ARTÍCULO
TITULO

A Numerical Study on the Performance of the 66k DWT Bulk Carrier in Regular and Irregular Waves

Gu-Hyeon Kim    
Seunghyun Hwang    
Soon-Hyun Lee    
Jun-Hee Lee    
Jun Hwangbo    
Kwang-Soo Kim and Kwang-Jun Paik    

Resumen

Accurate resistance performance evaluation is essential to predict the minimum propulsion horsepower required for ships in real sea. Therefore, in this paper, the added resistance performance of K-Supramax in various wave conditions was calculated using CFD (Computational Fluid Dynamics). First, to compare the resistance performance according to the DOF (Degree of Freedom), the added resistance performance in the head regular wave was investigated and compared with the experiment. The 2DOF and 6DOF results in the head regular wave had no significant differences. Second, to compare the resistance performance among various wave conditions, the effect of the heading angle was analyzed by comparing resistance and motion RAOs (Response Amplitude Operators) in bow quartering sea conditions using 6DOF. The added resistance showed the highest value near the resonance frequency of 170°. As the heading angle increased, the added resistance tended to decrease, regardless of the wavelength ratio. Also, the added resistance performance in irregular waves was investigated with reference to the adverse conditions. The spectral method, which linearly superimposes regular wave results, and the added resistance generated during irregular waves directly through CFD were compared. The resistance in irregular waves increased by approximately 92% for the spectral method and by approximately 72% for the direct irregular wave calculation compared to the resistance in calm water. In addition, the PSD (Power Spectral Density) of resistance and the distribution of motion RAOs obtained from direct irregular wave calculations were investigated.

 Artículos similares

       
 
Taufiq Saidi,Taufiq Saidi,Muttaqin Hasan,Muttaqin Hasan,Zahra Amalia,Muhammad Iqbal,Muhammad Iqbal     Pág. 155 - 164
The use of synthetic Fiber Reinforced Polymer (FRP) as a composite material is an alternative material that has been widely used for strengthening and repairing reinforced concrete structures. However, the high price is one of the obstacles in applying s... ver más

 
Jiaqi Hu, Yin Gu, Jinhuang Yan, Ying Sun and Xinyi Huang    
With the convenient and fast requirements for construction in bridge engineering, prefabricated assembly technology is widely applied in engineering construction. Typically, prefabricated bridge decks are connected through cast-in-place wet joints. Wet j... ver más
Revista: Applied Sciences

 
Liang Dai, Chaojun Jia, Lei Chen, Qiang Zhang and Wei Chen    
The intricate geological conditions of reservoir banks render them highly susceptible to destabilization and damage from fluctuations in water levels. The study area, the Cheyipin section of the Huangdeng Hydroelectric Station, is characterized by numero... ver más
Revista: Applied Sciences

 
Yufan He, Can Luo, Li Cheng, Yandong Gu and Bin Gu    
The shaft-type tubular pumping station has the remarkable characteristics of a large flow rate and high efficiency. It can realize the functions of irrigation, pumping, and drainage through pumping and generating conditions considering tides. Moreover, i... ver más

 
Tianhui Fan, Jianhu Fang, Xinkuan Yan and Yuan Ma    
The floating offshore wind turbine provides a feasible solution for the development of renewable ocean energy. However, the sizeable rotor diameter of the wind turbine results in large wind heeling moments and pitch amplitude. It will increase the struct... ver más