Resumen
The numerical simulation method was used to investigate the deflection and deformation process of a circular lubricating oil jet in transverse shear airflow. The numerical model was compared and validated against the experimental data. The physical parameters of Mobil jet Oil II were utilized in this simulation with the nozzle diameter ranging from 0.5 to 2.5 mm, the maximum liquid/gas momentum ratios varying from 10.35 to 165.50, and the injection angle ranging from 0 to 30° in the opposite airflow direction. The results show that an increase in the nozzle diameter decreases the degree of jet deflection. The higher airflow velocity causes more fluctuations in the oil-jet trajectory, while the higher oil-injection velocity reduces fluctuations in the trajectory. The parabolic curve equations were used to derive the trajectory equations for the jet column?s pre-disintegration under both vertical incidence and a small angle of reverse airflow. The nozzle diameter and maximum oil/air momentum ratio were used to obtain a formula for the trajectory curve of the lubricating oil. Additionally, a formula for fitting the trajectory curve of oil injected in the opposite airflow direction regarding the injection angle was developed.