Resumen
In the past, due to improper sludge treatment technology and the absence of treatment standards, some municipal sludge was simply dewatered and then sent to landfills, occupying a significant amount of land and posing a serious threat of secondary pollution. To free up land in the landfill area for the expansion of a large-scale wastewater treatment plant (WWTP) in Shanghai, in this study, we conducted comprehensive pilot research on the entire chain of landfill sludge reprocessing and resource utilization. Both the combination of polyferric silicate sulfate (PFSS) and polyetheramine (PEA) and the combination of polyaluminum silicate (PAS) and polyetheramine (PEA) were used for sludge conditioning before dewatering, resulting in dewatered sludge with approximately 60% moisture content. The combined process involved coagulation and sedimentation, flocculation, and oxidation to treat the leachate generated during dewatering. The treatment process successfully met the specified water pollutant discharge concentration limits for the leachate, with the concentration of ammonia nitrogen in the effluent as low as 15.6 mg/L. Co-incineration in a power plant and modification were applied to stabilize and harmlessly dispose of the dewatered sludge. The coal-generating system ran stably, and no obvious problems were observed in the blending process. In the modification experiment, adding 5% to 7% of the solidifying agent increased the sludge bearing ratio by 53% and 57%, respectively. This process effectively reduced levels of fecal coliforms and heavy metals in the sludge but had a less noticeable effect on organic matter content. The modified sludge proved suitable for use as backfill material in construction areas without requirements for organic matter. The results of this study provide valuable insights for a completed full-scale landfill sludge reclamation and land resource release project.