Redirigiendo al acceso original de articulo en 20 segundos...
Inicio  /  Coatings  /  Vol: 7 Núm: 7 Par: July (2017)  /  Artículo
ARTÍCULO
TITULO

Effect of Si3N4 Addition on Oxidation Resistance of ZrB2-SiC Composites

Manab Mallik    
Kalyan Kumar Ray and Rahul Mitra    

Resumen

The oxidation behavior of ZrB2-20 vol % SiC and ZrB2-20 vol % SiC-5 vol % Si3N4 composites prepared by hot-pressing and subjected to isothermal exposure at 1200 or 1300 °C for durations of 24 or 100 h in air, as well as cyclic exposure at 1300 °C for 24 h, have been investigated. The oxidation resistance of the ZrB2-20 vol % SiC composite has been found to improve by around 20%?25% with addition of 5 vol % Si3N4 during isothermal or cyclic exposures at 1200 or 1300 °C. This improvement in oxidation resistance has been attributed to the formation of higher amounts of SiO2 and Si2N2O, as well as a greater amount of continuity in the oxide scale, because these phases assist in closing the pores and lower the severity of cracking by exhibiting self-healing type behavior. For both the composites, the mass changes are found to be higher during cyclic exposure at 1300 °C by about 2 times compared to that under isothermal conditions.

 Artículos similares

       
 
Boya Yu, Yuying Chai and Chao Wang    
The present study focuses on the impact of exterior traffic noises on sound environment evaluation in office spaces, considering their interaction with interior noises. There were three interior noise conditions: silence, air-conditioner noise, and irrel... ver más
Revista: Applied Sciences

 
Rafal Krakowski and Kazimierz Witkowski    
This article shows the effect of the addition of effective microorganisms and silver on the exhaust gas composition and fuel consumption. Exhaust emission standards are becoming increasingly stringent, which makes it difficult for engine manufacturers to... ver más
Revista: Applied Sciences

 
Qiang Cheng, Yong Cao, Zhifeng Liu, Lingli Cui, Tao Zhang and Lei Xu    
The computer numerically controlled (CNC) system is the key functional component of CNC machine tool control systems, and the servo drive system is an important part of CNC systems. The complex working environment will lead to frequent failure of servo d... ver más
Revista: Applied Sciences

 
Haoran Zhu, Liping Zhu, Lun Luo and Jiao Li    
Based on 360 event-based precipitation samples collected at six stations on the North Tibetan Plateau (NTP) in 2019?2020, we analyzed the influence of meteorological parameters, sub-cloud evaporation, moisture sources, and moisture transmission pathways ... ver más
Revista: Water

 
Wenjie Shen, Suofang Wang and Xiaodi Liang    
Impellers are utilized to increase pressure to ensure that a radial pre-swirl system can provide sufficient cooling airflow to the turbine blades. In the open literature, the pressurization mechanism of the impellers was investigated. However, the effect... ver más
Revista: Aerospace