Redirigiendo al acceso original de articulo en 19 segundos...
ARTÍCULO
TITULO

Determining mechanical properties of a pressure fire hose the type of «T»

Oleksiy Larin    
Oleksandr Morozov    
Sergii Nazarenko    
Gennadiy Chernobay    
Andrii Kalynovskyi    
Roman Kovalenko    
Svitlana Fedulova    
Pavlo Pustovoitov    

Resumen

Experimental research into determining the mechanical properties (elastic and dissipative) of the pressure fire hose of type «T» with an inner diameter of 66 mm under conditions of static load were presented. The experiment was conducted on the experimental setup, which makes it possible to measure force and deformation. In the course of research, a series of field experiments in stretching with the sample under conditions of static loading-unloading cycles was carried out. The tests consisted of 5 cycles (modes) of loading-unloading, which were performed with a two-minute interval. Taking into consideration the experimental data, the elasticity module at stretching the material of the hose in the longitudinal (along the base) direction was determined. It was established that numerical results of mechanical properties depend on the hose loading «history», that is, in the first two load modes, elasticity modules increased and were stabilized only in the subsequent modes. The above, along with a significant reduction in residual deformations, increases the elastic properties of the fire hose material.The results of the conducted studies showed that in the first two cycles, the material demonstrates short-term creep, which gets stabilized in modes 4?5. To generalize the experimental research, the results were approximated by corresponding trend lines. The curves of the sample deformation, which under conditions of cyclic loading-unloading formed the hysteresis loops, were determined. The hysteresis loops obtained during the study showed that in the first two modes, the loop are subjected to quantitative and qualitative changes, specifically, the slope of the hysteresis loop and its area decreases.It was determined that a change of the properties of the material of the fire hose at consecutive loading-unloading deformation cycles are reversed, the gaps between the deformation cycles result in partial restoration of the mechanical characteristics, approximating them to the initial values. Relaxation time is from several hours to several days and even weeks, which depends heavily on the magnitude of the previous relative deformation

 Artículos similares

       
 
Adrian Soica    
The reconstruction of traffic accidents has grown as an interdisciplinary field, encompassing bodies of research from automotive engineering, traffic and transport engineering, biomechanics, and forensic sciences. In this work, a method is proposed by wh... ver más
Revista: Applied Sciences

 
Piotr Kaczmarzyk, Pawel Janik, Daniel Maloziec, Wojciech Klapsa and Lukasz Wargula    
During rescue operations, one of the important parameters determining the effectiveness of the implementation of tactical mechanical ventilation is the selection of the appropriate size of the outlet opening. The objective of this article is to determine... ver más
Revista: Applied Sciences

 
Yizhe Wu, Huanling Wang and Xinyan Guo    
In constructing hydraulic tunnels, construction disturbances and complex geological conditions can induce variations in the surrounding rock parameters. To navigate the complex non-linear interplay between rock material parameters and tunnel displacement... ver más
Revista: Applied Sciences

 
Artur Kulaszka, Józef Blachnio and Henryk Borowczyk    
The reliability and operational safety of an aircraft engine gas turbine are extremely important in terms of its operation. In the course of operation, these turbines undergo complex thermal, mechanical, aerodynamic, and chemical exhaust gas loads. Due t... ver más
Revista: Aerospace

 
Ziyu Wang, Xiangyu Zhao, Xin Chen, Peng Cao, Liang Cao and Wenjing Chen    
To improve the mechanical properties of calcareous sand, it is proposed that microbial induced calcium carbonate precipitation (MICP) technology be used. A series of solidification tests were conducted in natural seawater and freshwater environments. The... ver más