Resumen
The formulations of tasks modelling embankments on soft soil, improved with columns and with reinforced load transfer platform (LTP), differ significantly. One of these differences is the distribution of equivalent load modelling part of the load carried by the LTP reinforcement and soft soil. This article analyses the influence of the nature of the load-modelling linear function, i.e., inverse triangular, uniformly distributed and triangular, as well as intermediate distributions. In total, 41 distributions of equivalent load were considered, and the results of the obtained deflection functions were compared with the measurement results of reinforcement deflection for 5 cases of experimental research available in the literature. A measure of the accuracy of mapping the reinforcement deflection curve was proposed as a relative error in relation to the deflection curve resulting from experimental measurements. Based on the analysis of the mapping error, it was determined that among the three commonly used distributions, the inverse triangular distribution shows the best fit in most of the analysed cases. However, not in every single case this is the distribution leading to a solution that best describes the behaviour of the geosynthetic reinforcement.