Redirigiendo al acceso original de articulo en 15 segundos...
Inicio  /  Future Internet  /  Vol: 14 Par: 11 (2022)  /  Artículo
ARTÍCULO
TITULO

Identification of Risk Factors Using ANFIS-Based Security Risk Assessment Model for SDLC Phases

Rasheed Gbenga Jimoh    
Olayinka Olufunmilayo Olusanya    
Joseph Bamidele Awotunde    
Agbotiname Lucky Imoize and Cheng-Chi Lee    

Resumen

In the field of software development, the efficient prioritizing of software risks was essential and play significant roles. However, finding a viable solution to this issue is a difficult challenge. The software developers have to adhere strictly to risk management practice because each phase of SDLC is faced with its individual type of risk rather than considering it as a general risk. Therefore, this study proposes an adaptive neuro-fuzzy inference system (ANFIS) for selection of appropriate risk factors in each stages of software development process. Existing studies viewed the SDLC?s Security risk assessment (SRA) as a single integrated process that did not offer a thorough SRA at each stage of the SDLC process, which resulted in unsecure software development. Hence, this study identify and validate the risk factors needed for assessing security risk at each phase of SDLC. For each phase, an SRA model based on an ANFIS was suggested, using the identified risk factors as inputs. For the logical representation of the fuzzification as an input and output variables of the SRA risk factors for the ANFIS-based model employing the triangular membership functions. The proposed model utilized two triangular membership functions to represent each risk factor?s label, while four membership functions were used to represent the labels of the target SRA value. Software developers chose the SRA risk factors that were pertinent in their situation from the proposed taxonomy for each level of the SDLC process as revealed by the results. As revealed from the study?s findings, knowledge of the identified risk factors may be valuable for evaluating the security risk throughout the SDLC process.

 Artículos similares

       
 
Matteo Dellacasagrande, Davide Lengani, Daniele Simoni and Marina Ubaldi    
The bursting phenomenon consists in the switch of a laminar separation bubble from a short to a long configuration. In the former case, reduced effects on profile pressure distribution are typically observed with respect to the attached condition. On the... ver más

 
Meng Li, Jiqiang Liu and Yeping Yang    
Data governance is an extremely important protection and management measure throughout the entire life cycle of data. However, there are still data governance issues, such as data security risks, data privacy breaches, and difficulties in data management... ver más
Revista: Future Internet

 
Shalaka Hire, Sayali Sandbhor and Kirti Ruikar    
With developments in Industry 4.0, there is growing momentum to adopt technology-assisted tools to support existing processes. Even though most construction processes are now computerized, safety procedures have not yet fully embraced the digital revolut... ver más
Revista: Buildings

 
Elhosin Yousri, Ahmed El Badawy Sayed, Moataz A. M. Farag and Ahmed Mohammed Abdelalim    
Risk identification is integral to construction management. The severe consequences of identified risk factors on time and cost performance can be addressed by improved risk management. The identification and preparation of responses to risk factors affe... ver más
Revista: Buildings

 
Susana Román-Pérez, Raúl Aguirre-Gómez, Juan Eugenio Hernández-Ávila, Luisa Basilia Íñiguez-Rojas, René Santos-Luna and Fabián Correa-Morales    
Dengue is a public health problem in more than 100 countries around the world and in virtually the entire region of the Americas, including Mexico. Mosquitoes of the genus Aedes aegypti transmit dengue; its reproduction requires certain geographical, epi... ver más