Acceso al sitio web del Consejo de Políticas de Infraestructura

   
Redirigiendo al acceso original de articulo en 16 segundos...
ARTÍCULO
TITULO

Friction Behavior of Engineering Polymers Treated by Atmospheric DBD Plasma

Hayder Al-Maliki    
Gábor Kalácska    

Resumen

The frictional behavior of (PA6 E and PETP) engineering polymers commonly used in the industry were investigated implying 3D surface topography due to Dielectric Barrier Discharge (DBD) source, atmospheric cold plasma surface treatment and compared to the pristine surface results under the same test conditions. The 3D surface topography shows a decrease in the surface roughness after treatment and keeps good topographical stability with the function of time. The friction coefficient of treated samples were lower than the pristine one under ?run-out? lubrication conditions in line with surface characterization results.

PÁGINAS
pp. 303 - 308

 Artículos similares

       
 
Zhijie Sun, Pengfei Li, Xiuli Du and Xuanyu Yang    
There are a large number of structural planes distributed in the surrounding rock of a tunnel, and this is one of the key factors causing a tunnel?s instability. Due to different geological and historical conditions, the distribution characteristics and ... ver más
Revista: Applied Sciences

 
Xiaojie Jiao, Cheng Cheng, Yubing Song, Gang Wang and Linjuan He    
The rock deformation and failure characteristics and mechanisms are very important for stability evaluation and hazard control in rock engineering. The process of rock deformation and failure is often accompanied by temperature changes. It is of great si... ver más
Revista: Applied Sciences

 
Kanmin Shen, Kuanjun Wang, Juntian Yao and Jian Yu    
The control centers of wind power plants are usually located in coastal tidal flat areas. A thick fill should be placed at the original ground level to ensure that the design elevation of the control centers is maintained above the water table. However, ... ver más

 
Bin Jiang, Weiheng Li, Peiyi Zhao, Lili Fan and Meng Sun    
In the milling process, the friction and wear of the tooth minor flank of the square shoulder milling cutter directly affects the machined surface quality and the cutter?s life. The friction of the minor flank of the cutter tooth presents a nonlinear dis... ver más
Revista: Applied Sciences

 
Hongyuan Liu, Mingxing Zhu, Xiaojuan Li, Guoliang Dai, Qian Yin, Jing Liu and Chen Ling    
At present, the interface shear test is mainly used to evaluate the anti-sliding performance of the new foundation base. However, the traditional interface shear test has certain limitations in simulating the load change during the construction process a... ver más
Revista: Applied Sciences