Resumen
In this work, homogeneous, thin-film proton exchange membranes (PEMs) with superior proton conductivities and high methanol rejection were fabricated via a facile synthesis procedure. Sulfonated polyether ether ketone (sPEEK) was crosslinked via a Friedel?Crafts reaction by a,a'-dichloro-p-xylene, a non-hazardous and hydrophobic compound. PEMs with varying crosslinking and sulfonation degrees were fabricated to overcome the traditional trade-off between methanol rejection and proton conductivity. The sulfonation of PEEK at 60 °C for 24 h resulted in a sulfonation degree of 56%. Those highly sulfonated backbones, in combination with a low membrane thickness (ca. 20 µm), resulted in proton conductivities superior to Nafion 117. Furthermore, X-ray photoelectron spectroscopy proved it was possible to control the crosslinking degree via the crosslinking time and temperature. The PEMs with the highest crosslinking degree showed better methanol rejection compared to the commercial benchmark. The introduction of the crosslinker created hydrophobic membrane sections, which reduced the water and methanol uptake. Subsequently, the membrane became denser due to the crosslinking, hindering the solute permeation. Those two effects led to lower methanol crossovers. This study proved the successful fabrication of PEMs overcoming the trade-off between proton conductivity and methanol rejection, following a facile procedure using low-cost and non-hazardous materials.