Resumen
Due to the limitations of measurement equipment and the influence of factors such as the environment and target, measurement errors may occur during the data acquisition process of airborne LiDAR bathymetry (ALB). The refractive index of water is defined as the propagation ratio of the speed of light waves in a vacuum to that in water; this ratio influences not only the propagation speed of the laser pulse in water but also the propagation direction of the laser pulse entering water. Therefore, the influence of refractive index changes in water on the ALB errors needs to be analyzed. To this end, the principle of ALB is first briefly introduced. Then, the calculation method for the refractive index of water is described with Snell?s law and an empirical formula. Finally, the influence of refractive index changes on ALB errors is analyzed using the derived formula at the water?air interface and in the water column. The experimental results showed that in a constant elevation of 50 m for a bathymetric floor, the refractive index changes in water caused by temperature, salinity, and depth are less than 0.001. The maximum bathymetric error and maximum planimetric error caused by the refractive index changes at the water?air interface are 0.036 m and 0.015 m, respectively. The ALB errors caused by refractive index changes in the water column are relatively low, and the water column does not need to be layered to calculate the ALB errors. The influence of refractive index changes in water on the ALB error is minimal, accounting for only a small proportion of all bathymetric errors. Thus, it is necessary to determine whether the effect of the ALB error due to refractive index changes in water needs to be corrected based on the accuracy requirements of the data acquisition. This study and analysis can provide a reference basis for correcting ALB errors.