ARTÍCULO
TITULO

Optimum combination of process parameters to optimize Surface Roughness and Chip Thickness during End Milling of Aluminium 6351-T6 Alloy Using Taguchi Grey Relational Analysis

Reddy Sreenivasulu    

Resumen

No disponible

 Artículos similares

       
 
Junartho Halomoan, Kalamullah Ramli, Dodi Sudiana, Teddy Surya Gunawan and Muhammad Salman    
More than 1.3 million people are killed in traffic accidents annually. Road traffic accidents are mostly caused by human error. Therefore, an accurate driving fatigue detection system is required for drivers. Most driving fatigue detection studies concen... ver más
Revista: Information

 
Mina Tadros, Manuel Ventura and C. Guedes Soares    
This paper presents a review of the different methods and techniques used to optimize ship hulls over the last six years (2017?2022). This review shows the different percentages of reduction in ship resistance, and thus in the fuel consumption, to improv... ver más

 
Tharaa M. Al-Zghoul, Zakaria Al-Qodah and Ahmad Al-Jamrah    
The combination of the chemical coagulation-assisted electrocoagulation (CC-EC) process with a solar photovoltaic energy source has attracted increasing attention for the efficient removal of chemical oxygen demand (COD) from pharmaceutical wastewater. I... ver más
Revista: Water

 
Abdulrahman Mubarark AlAli, Abdelrahim Salih and Abdalhaleem Hassaballa    
This paper aimed to map areas prone to flooding in the Wadi Hanifah drainage basin located in the Riyadh region, and identify the most important factors that contribute to flooding through examining the influence of ten topographical, hydrological, and e... ver más
Revista: Water

 
Xiaobin Xu, Ruoyu Wang, Xianjun Yu, Guangfeng An, Ying Qiu and Baojie Liu    
Three-dimensional blading is an efficient technique in compressor aerodynamic design, and its function mechanism in the cantilevered stator needs to be addressed. This paper focuses on the sweep and dihedral in the cantilevered stator and seeks to expose... ver más
Revista: Applied Sciences