Inicio  /  Water  /  Vol: 9 Núm: 8 Par: 0 (2017)  /  Artículo
ARTÍCULO
TITULO

Agreement of Four Equations for Computing Dewfall in Northern Germany

Huijie Xiao    
Ralph Meissner    
Heinz Borg    
Ruoshui Wang    
Qiqi Cao    

Resumen

The energy balance (EB), turbulent vapour transport (TVT), Penman-Monteith (PM) and Bowen ratio energy balance (BREB) equation were used to estimate dewfall based on meteorological data. Initially there were big disagreements between the estimates from these four equations. However, after multiplying the heat and vapour conductance terms by 0.33 the agreement was much better. This implies that the disagreements derived from improper conductance values. Initially we did not consider the effect of atmospheric stability on the conductances. With stability correction the conductances were on average 0.5 times the values without stability correction. To arrive at the aforementioned 0.33, the conductances with stability correction still need to be lower by a factor of 0.66. The value of the von Karman constant and the relationships for the zero plane displacement and the roughness length we used in our conductance computations are widely used, but not the only possible ones. With different values and relationships also suggested in the literature one can reach this factor. However, it is also possible that our wind speed data contributed to the fact that the conductances we computed were too high. Their computation for a given canopy?atmosphere system requires wind speeds from a wind profile in equilibrium with the vegetation. This in turn requires an adequate fetch around the investigated surface. The highly varied vegetation in and around the site where the study was conducted makes adequate fetch rather doubtful. To obtain valid conductance values the atmospheric stability conditions must be considered, the appropriate values for the von Karman constant, the zero plane displacement and roughness length must be used, and there must be adequate fetch. The BREB equation does not contain a conductance term and therefore does not suffer from the problems just stated. The other three equations do. However, the BREB, like the EB and TVT equations, need the surface temperature which is not routinely measured. This then leaves the PM equation from which this temperature has been eliminated as the only option. Hence, in a future study dewfall estimates from the PM equation should be compared with direct measurements with a high precision weighing lysimeter.

 Artículos similares

       
 
Christian Lehr, Pascal Munsch, Romuald Skoda and Andreas Brümmer    
The acoustic properties of a single-stage centrifugal pump with low specific speed are investigated by means of compressible 3D CFD simulations (URANS) and experiments. In order to determine the pump?s acoustic transmission and excitation characteristics... ver más

 
Guoxu Niu, Yaoyong Chen, Jiao Lv, Jing Zhang and Ning Fan    
A two-dimensional viscous numerical wave tank coded mass source function in a computational fluid dynamics (CFD) software Flow-3D 11.2 is built and validated. The effect of the core influencing factors (draft, breakwater width, wave period, and wave heig... ver más

 
Di Wu, Jie Jiang, Fangyi Wang, Yunru Luo, Xiangdong Lei, Chengguang Lai, Xushu Wu and Menghua Xu    
With the rapid development of urbanization and a population surge, the drawback of water pollution, especially eutrophication, poses a severe threat to ecosystem as well as human well-being. Timely monitoring the variations of water quality is a preceden... ver más
Revista: Water

 
Sellaperumal Pazhanivelan, Vellingiri Geethalakshmi, Venkadesh Samykannu, Ramalingam Kumaraperumal, Mrunalini Kancheti, Ragunath Kaliaperumal, Marimuthu Raju and Manoj Kumar Yadav    
The prevalence of the frequent water stress conditions at present was found to be more frequent due to increased weather anomalies and climate change scenarios, among other reasons. Periodic drought assessment and subsequent management are essential in e... ver más
Revista: Water

 
Wenbin Liu, Youshan Wang and Yuchen Ji    
Landing impact load design is essential, but the process has rarely been fully described, and some designers have even neglected the differences between wheel-axle and ground-contact loads, as well as loads in the longitudinal direction, especially in ex... ver más
Revista: Aerospace