4 Art�culos

Development of the single-setup milling process model of the shaft support necks and cams

Acceso

en l�nea

Vitalii Kalchenko,Volodymyr Kalchenko,Natalia Sira,Olga Kalchenko,Volodymyr Vynnyk,Dmytro Kalchenko,Volodymyr Morochko P�g. 48 - 54

Three-dimensional geometrical modeling of the processes of allowance removal and shaping of support necks and cams of camshafts when milling with crossed axes of the tool and part is proposed. Single-setup milling of camshafts, which are widely used in a... ver m�s

Revista: Eastern-European Journal of Enterprise Technologies Formato: Electr�nico

Tabla de contenido: Vol: 4 Num: 1 Par: PP A�o: 2020

TECHNICAL AND ENERGY PARAMETERS IMPROVEMENT OF DIESEL LOCOMOTIVES THROUGH THE INTRODUCTION OF AUTOMATED CONTROL SYSTEMS OF A DIESEL

Acceso

en l�nea

M. I. Kapitsa,M. I. Martyshevskyi,D. N. Kyslyi,I. I. Palii P�g. 176 - 185

Revista: Nauka ta Progres Transportu Formato: Electr�nico

Tabla de contenido: Vol: 0 Num: 3 Par: 0 A�o: 2015

System Design and Analysis of a Directly Air-Assisted Turbocharged SI Engine with Camshaft Driven Valves

Acceso

en l�nea

Christoph Voser, Christopher Onder and Lino Guzzella

The availability of compressed air in combination with downsizing and turbocharging is a promising approach to improve the fuel economy and the driveability of internal combustion engines. The compressed air is used to boost and start the engine. It is g... ver m�s

Revista: Energies Formato: Electr�nico

Tabla de contenido: Vol: 6 Num: 4Pages1802-2318 Par: April A�o: 2013

« Anterior P�gina: 1 de 1 Siguiente »