|
|
|
Felix Czwielong and Stefan Becker
A novel active turbulence grid of the Institute of Fluid Mechanics at FAU Erlangen-Nuremberg is introduced. The focus of this grid is not on basic investigations of fluid mechanics, as is usually the case with active turbulence grids, but the generation ...
ver más
|
|
|
|
|
|
|
Lorenzo Tieghi, Giovanni Delibra, Johan van der Spuy and Alessandro Corsini
Air-cooled condensers (ACCs) are commonly found in power plants working with concentrated solar power or in steam power plants operated in regions with limited water availability. In ACCs, the flow of air is driven toward the heat exchangers by axial fan...
ver más
|
|
|
|
|
|
|
Matteo Dellacasagrande, Edward Canepa, Andrea Cattanei and Mehrdad Moradi
The present work reports an experimental study of the leakage flow in a low-speed fan ring. Existing 2D Particle Image Velocimetry (PIV) measurements taken in a meridional plane in front of the rotor gap have been further processed and analyzed by means ...
ver más
|
|
|
|
|
|
|
Thomas Carolus and Konrad Bamberger
This study targets determining impellers of impeller-only axial fans with an optimal hub-to-tip ratio for the highest achievable total-to-static efficiency. Differently from other studies, a holistic approach is chosen. Firstly, the complete class of the...
ver más
|
|
|
|
|
|
|
Fredrik Marincowitz, Michael Owen, Jacques Muiyser and Peter Holkers
Ambient wind has a negative effect on mechanical forced-draft direct air-cooled steam condenser (ACC) fan volumetric performance, and increases dynamic fan blade loading. Investigating these effects directly using on-site measurement or numerical analysi...
ver más
|
|
|
|
|
|
|
Gábor Daku and János Vad
This paper presents a critical overview on worst-case design scenarios for which low-speed axial flow fans may exhibit an increased risk of blade resonance due to profile vortex shedding. To set up a design example, a circular-arc-cambered plate of 8% re...
ver más
|
|
|
|
|
|
|
Emmanuel Benichou, Nicolas Binder, Yannick Bousquet and Xavier Carbonneau
This paper introduces a semi-analytical approach which enables one to deal with distorted inflow in axial fans or compressors. It is inspired by the classical parallel compressor (PC) theory but relies on a local flow-loading coefficient formalism. It is...
ver más
|
|
|
|
|
|
|
Gino Angelini, Alessandro Corsini, Giovanni Delibra and Lorenzo Tieghi
Since the 1960s, turbomachinery design has mainly been based on similarity theory and empirical correlations derived from experimental data and manufacturing experience. Over the years, this knowledge was consolidated and summarized by parameters such as...
ver más
|
|
|
|
|
|
|
Till Heinemann and Stefan Becker
In thermal power plants equipped with air-cooled condensers (ACCs), axial cooling fans operate under the influence of ambient flow fields. Under inlet cross-flow conditions, the resultant asymmetric flow field is known to introduce additional harmonic fo...
ver más
|
|
|
|
|
|
|
Alessandro Corsini, Anthony G. Sheard
Pág. 3 - 16
The paper presents a design procedure for anti-vortex end-plates that are fitted to tip limited blades of the subsonic axial fans utilised in compact cooling units. The authors study the impact of tip leakage vortex bursting on the performance of the stu...
ver más
|
|
|
|