|
|
|
|
|
Alessio Siciliano, Giulia Maria Curcio and Carlo Limonti
The pollution of water by nitrates represents an important environmental and health issue. The development of sustainable technologies that are able to efficiently remove this contaminant is a key challenge in the field of wastewater treatment. Chemical ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Byung-Moon Jun, Yejin Kim, Jonghun Han, Yeomin Yoon, Jeonggwan Kim and Chang Min Park
For this study, we applied activated biochar (AB) and its composition with magnetite (AB-Fe3O4) as adsorbents for the removal of polychlorophenols in model wastewater. We comprehensively characterized these adsorbents and performed adsorption tests under...
ver más
|
|
|
|
|
|
|
|
|
|
|
Deniz Yildiz, Ugur Fidan, Mehmet Yildiz, Büsra Er, Gürbüz Ocak, Fatih Güngör, Ijlal Ocak and Zeki Akyildiz
This study aims to develop an interactive language learning game and explore its efficacy for English language learners. A computer-generated playground was projected onto a large classroom floor (4 × 3 m) with a wide-angle projection device. A Kinect de...
ver más
|
|
|
|
|
|
|
|
|
|
|
Michele Tonan, Alberto Pasetto and Alberto Doria
In this paper, the possibility of harvesting energy from the vibrations of a plate is analyzed. The harvester takes the form of a cantilever dynamic vibration absorber equipped with a piezoelectric layer and tuned by means of a tip mass to the first mode...
ver más
|
|
|
|
|
|
|
|
|
|
|
?iga Unuk and Milan Kuhta
A nonlinear semi-numeric and finite element analysis of three-point bending tests of notched polymer fiber-reinforced concrete prisms was performed. The computational and experimental results were compared in terms of the load-displacement behavior. The ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Abdul Basit, Safeer Abbas, Muhammad Mubashir Ajmal, Ubaid Ahmad Mughal, Syed Minhaj Saleem Kazmi and Muhammad Junaid Munir
This study undertakes a comprehensive experimental and numerical analysis of the structural integrity of buried RC sewerage pipes, focusing on the performance of two distinct jointing materials: cement mortar and non-shrinkage grout. Through joint shear ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Panagiotis D. Kordas, George N. Lampeas and Konstantinos T. Fotopoulos
The main purpose of this study comprises the design and the development of a novel experimental configuration for carrying out tests on a full-scale stiffened panel manufactured of fiber-reinforced thermoplastic material. Two different test-bench design ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Changkun Yu, Zhigang Wu and Chao Yang
Slender vehicles often encounter significant aeroservoelastic challenges due to their low elastic mode frequencies and wide servo control system bandwidths. Traditional analysis methods have limitations, including low modeling accuracy for real vehicles ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Hassan Aleisa, Konstantinos Kontis and Melike Nikbay
Developing wind tunnel models is time consuming, labor intensive, and expensive. Rapid prototyping for wind tunnel tests is an effective, faster, and cheaper method to obtain aerodynamic performance results while considerably reducing acquisition time an...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ayman El-Zohairy, Hani Salim, Hesham Shaaban and Mahmoud T. Nawar
Fatigue in steel?concrete composite beams can result from cyclic loading, causing stress fluctuations that may lead to cumulative damage and eventual failure over an extended period. In this paper, the experimental findings from fatigue loading tests on ...
ver más
|
|
|
|
|
|