24   Artículos

 
en línea
Feng Hu and Hongbing Xin    
The flexible bearing is the kernel component of the cam wave generator. In precision transmission applications such as miniature robot joints, flexible bearings are required to have a smaller mass, lower moment of inertia, and larger inner diameter. Base... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Guoqiang Zhang, Irfan Ahmed Khan, Amil Daraz, Abdul Basit and Muhammad Irshad Khan    
In seaports, low-carbon energy systems and energy efficiency have become increasingly important as a result of the evolution of environmental and climate change challenges. In order to ensure the continued success of seaports, technological advancements ... ver más
Revista: Journal of Marine Science and Engineering    Formato: Electrónico

 
en línea
Anukriti Pokhriyal, José Luis Domínguez-García and Pedro Gómez-Romero    
The rapid increase in the integration of renewable energy sources into the electrical grid is posing new challenges for the dynamic responses due to the global inertia reduction. In this regard, the impact on frequency stability of such reduction and the... ver más
Revista: Clean Technologies    Formato: Electrónico

 
en línea
Shun Sang, Binhui Pei, Jiejie Huang, Lei Zhang and Xiaocen Xue    
Voltage source (VS) control based on inertia synchronization is a novel phase lock loop (PLL)-less autonomous grid-synchronization control strategy suitable for the permanent magnet synchronous generator (PMSG)-based wind turbine. It can autonomously sen... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Abid Soomro, Keith R. Pullen and Mustafa E. Amiryar    
Due to low system inertia in microgrids, frequencies may vary rapidly from the nominal value, leading to the complete blackout of the system unless there is an adequate spinning reserve available for balancing the supply with the demand load. This issue ... ver más
Revista: Clean Technologies    Formato: Electrónico

 
en línea
Dejian Yang, Hong-Chao Gao, Lei Zhang, Jingjiao Li, Xinsong Zhang and Liang Hua    
Converter-interfaced doubly-fed induction generators (DFIGs) can provide short-term frequency support (STFS) capability by releasing rotating kinetic energy. After arresting the frequency decrease, the rotor speed should return to its initial operating c... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Oluwafemi E. Oni    
Inter-area oscillation caused by weak interconnected lines or low generator inertia is a critical problem facing power systems. This study investigated the performance analysis of a multi-terminal high voltage direct current (MTDC) on the damping of inte... ver más
Revista: Journal of Energy in Southern Africa    Formato: Electrónico

 
en línea
Ah-Der Lin, Tsung-Pin Hung, Jao-Hwa Kuang and Hsiu-An Tsai    
A parallel planetary gear train design is proposed to construct the wind turbine system that has double inputs and one output. The proposed system is flexible for the application, which may use a combination of two rotors, as used for horizontal axis or ... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Weichao Zhang, Xiangwu Yan and Hanyan Huang    
Renewable generation brings both new energies and significant challenges to the evolving power system. To cope with the loss of inertia caused by inertialess power electronic interfaces (PEIs), the concept of the virtual synchronous generator (VSG) has b... ver más
Revista: Applied Sciences    Formato: Electrónico

 
en línea
Mpeli Rampokanyo, Pamela Ijumba-Kamera    
Erosion of power system inertial energy due to high penetration levels of renewable energy (RE) sources in a power system is a current teething issue with most system operators everywhere. The main issue is displacement of synchronous generators with inv... ver más
Revista: Journal of Energy in Southern Africa    Formato: Electrónico

« Anterior     Página: 1 de 2     Siguiente »