|
|
|
|
|
Christopher Hartmann, Julia Schweikert, François Cottier, Ute Israel, Jochen Gier and Jens von Wolfersdorf
Experimental results for the transient heat transfer characteristics over a flat plate and over a plate with V-shaped ribs were compared to numerical results from a coupling environment applying FEM and CFD. In order to simulate transient effects in the ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Wooseok Jeong, Seungeon Jang and Hong-Jip Kim
Since a heat exchanger used in a gas generator of an open-cycle liquid rocket engine was operated in a high-temperature environment, the coupled analysis for heat transfer characteristics and structural integrity should be performed simultaneously. For t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Pavan Gowda M., Amit Baran Sharangi, Tarun Kumar Upadhyay, Nahaa M. Alotaibi, Modhi O. Alotaibi, Nawaf Alshammari and Mohd Saeed
With the objective of studying the influence of elicitors on the growth, yield, and quality of kalmegh, we carried out an investigation for two consecutive years. Nine treatments with three replications were laid out in a completely randomized design (CR...
ver más
|
|
|
|
|
|
|
|
|
|
|
Banghua Zhao, Sujun Dong, Chen Ding and Zhiliang Cui
The present study proposes a novel optimization strategy (NOS) for quasi-steady algorithms to optimize the initial error in the fast calculation of conjugate heat transfer (CHT) simulations. In this approach, the change in Nusselt number at the fluid?sol...
ver más
|
|
|
|
|
|
|
|
|
|
|
Andrew J. Clayton, Ali Abbas, Peter J. Siderfin, Stephen Jones, Ana Teloeken, Ochai Oklobia, John M. Walls and Stuart J. C. Irvine
CdTe solar cells were produced using metal organic chemical vapour deposition (MOCVD), which employed a (Zn,Al)S (AZS) high resistant transparent (HRT) layer at the transparent conducting oxide (TCO)/Cd(Zn)S emitter interface, to enable the higher anneal...
ver más
|
|
|
|
|
|
|
|
|
|
|
María Moncho Santonja, Bàrbara Micó-Vicent, Beatriz Defez, Jorge Jordán and Guillermo Peris-Fajarnes
The number of infectious spots or pathological structures recorded on dermatological images is a tool to aid in the diagnosis and monitoring of disease progression. Dermatological images for the detection and monitoring of the evolution of acne infection...
ver más
|
|
|
|
|
|
|
|
|
|
|
Patricia Jovicevic-Klug, László Tóth and Bojan Podgornik
In this research, Böhler K340 cold work tool steel was subjected to three different heat treatment protocols, conventional heat treatment (CHT), shallow cryogenic treatment (SCT), and deep cryogenic treatment (DCT). The study compares the effect of SCT a...
ver más
|
|
|
|
|
|
|
|
|
|
|
Patricia Jovicevic-Klug, Matic Jovicevic-Klug and Bojan Podgornik
The role of nitrogen, introduced by deep cryogenic treatment (DCT), has been investigated and unraveled in relation to induced surface chemistry changes and improved corrosion resistance of high-alloyed ferrous alloy AISI M35. The assumptions and observa...
ver más
|
|
|
|
|
|
|
|
|
|
|
Lucian Hanimann, Luca Mangani, Ernesto Casartelli, Elmar Gröschel and Magnus Fischer
The demand for increased turbomachinery performance, both, towards higher pressures and temperatures, leads to high thermal-loads of specific components and can critically affect mechanical integrity. In the particular case of rotating-disk configuration...
ver más
|
|
|
|
|
|
|
|
|
|
|
Sondre Norheim and Shokri Amzin
Gas turbine performance is closely linked to the turbine inlet temperature, which is limited by the turbine guide vanes ability to withstand the massive thermal loads. Thus, steam cooling has been introduced as an advanced cooling technology to improve t...
ver más
|
|
|
|
|
|