Resumen
Air-coupled ultrasonic guided A0 mode is already used for material characterization. By measuring the phase velocity of the A0 mode the elastic properties, such as the Young?s modulus, can be determined. The objective of this work was the development of measurement methods and corresponding signal processing procedures enabling the acquisition of spatial distributions of non-uniform elastic properties of thin films and plates. Those methods are based on the excitation of a slow sub-sonic A0 Lamb wave mode in a plate, the measurement of normal displacements at different distances from the source, the formation of the B-scan, and processing the collected signals. Two different signal processing methods were proposed and investigated. In the first method the all zero-crossing instants of the ultrasonic signals at different distances are found and from them spatial distributions of the A0 mode velocity are determined. According to the second method 2D spatial-temporal spectrum of the B-scan is calculated and propagating A0 modes with different velocities are identified. Efficiency of the proposed methods was evaluated theoretically and experimentally using thin mineral MICA paper samples, which is used in the electrical and aerospace industries as an insulating material. The zones with different A0 mode phase velocities (95 ± ?3 m/s and (106 ± ?6 m/s) at the frequency 47 kHz were identified.