|
|
|
|
|
M. I. Rodríguez-Tapiador, J. M. Asensi, M. Roldán, J. Merino, J. Bertomeu and S. Fernández
Copper nitride (Cu3N) has gained significant attention recently due to its potential in several scientific and technological applications. This study focuses on using Cu3N as a solar absorber in photovoltaic technology. Cu3N thin films were deposited on ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhen Zhou, Yanfeng Han and Jin Qian
Water lubrication has been widely used in marine equipment, where rubber bearings and seals suffer intense friction and severe wear under mixed and boundary conditions. It has good research prospects and practical value to study the composite of amorphou...
ver más
|
|
|
|
|
|
|
|
|
|
|
Mohammad Shah Jamal, Khan Sobayel, Halina Misran, Taskina Nasrin, Khaled Althubeiti, Hend I. Alkhammash, Md. Shahiduzzaman, Kamaruzzaman Sopian, Nowshad Amin and Md. Akhtaruzzaman
|
|
|
|
|
|
|
|
|
|
|
Zifeng Li, Guotan Liu, Guanqi Liu, Xiaoshuo Zhu and Yudong Fu
Nb-Si-C thin films were deposited onto Si(001) substrates by radio frequency (RF) magnetron sputtering using individual Nb, Si, and C targets. The effects of varying the sputtering power on the phase composition of the new thin films were studied. The st...
ver más
|
|
|
|
|
|
|
|
|
|
|
Slawomir Gulkowski and Ewelina Krawczak
Thin film Cu(In,Ga)Se2 (CIGS)-based solar cells with relatively high efficiency and low material usage might become a promising alternative for crystalline silicon technology. The most challenging task nowadays is to decrease the PV module fabrication co...
ver más
|
|
|
|
|
|
|
|
|
|
|
Muhammad Shahriar Bashar, Yulisa Yusoff, Siti Fazlili Abdullah, Mashudur Rahaman, Puvaneswaran Chelvanathan, Abdul Gafur, Farid Ahmed, Md Akhtaruzzaman and Nowshad Amin
In this paper, Zn1-xMgxS thin films were co-sputtered on glass substrates using ZnS and MgS binary target materials under various applied RF power. The compositional ratio of Zn1-xMgxS films was varied by changing the RF power at an elevated temperature ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Haili Zhao, Jingpei Xie and Aixia Mao
Most of the molybdenum (Mo) bilayer films are deposited by direct current (DC) magnetron sputtering at the bottom and the top layer (DC/DC). However, the deposition of Mo bilayer film by radio frequency (RF) Mo bottom layer and DC Mo top layer magnetron ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Andreea Groza, Dragana B. Dreghici and Mihai Ganciu
Calcium phosphate coatings were deposited on thermally sensitive polyprophylene substrates in radio frequency (rf) magnetron sputtering discharge. The steady state of the deposition plasma and its components were identified by deposition rate measurement...
ver más
|
|
|
|
|
|
|
|
|
|
|
M. Nur-E-Alam, Mikhail Vasiliev and Kamal Alameh
Highly bismuth-substituted iron garnet thin films are prepared on quartz substrates by using a radio frequency (RF) magnetron sputtering technique. We study the factors (process parameters associated with the RF magnetron sputter deposition technique) af...
ver más
|
|
|
|
|
|
|
|
|
|
|
Imane Bouabibsa, Salim Lamri and Frederic Sanchette
Metal containing hydrogenated diamond-like carbon coatings (Me-DLC, Me = Al, Ti, or Nb) of 3 ± 0.2 μm thickness were deposited by a magnetron sputtering-RFPECVD hybrid process in an Ar/H2/C2H2 mixture. The composition and structure were investi...
ver más
|
|
|
|
|
|