|
|
|
|
|
Zhao Ma, Junjie Ye, Xin Zhang and Wenhua Ye
To analyze the rock-breaking characteristics of an arcing-blade cutter in cutting red sandstone, a two-cutter cutting model was established based on the finite element method. Then, the cutting processes of the arcing-blade cutter at penetrations of 2 mm...
ver más
|
|
|
|
|
|
|
|
|
|
|
Kacey M. Wallace, Michael R. Brown, William C. Pannell, Jacob B. Daniels, Juliana C. Moore, Ayden K. McInnis, Paul T. Donahue and John C. Garner
Single-limb balance training is integral to preventing and rehabilitating lower extremity injuries. Previous investigations have shown that when using instability devices, differences may or may not exist in the postural sway parameters during use, depen...
ver más
|
|
|
|
|
|
|
|
|
|
|
Heng Liu, Wenzhi Xu, Quanchun Yuan, Jin Zeng, Xiaohui Lei and Xiaolan Lyu
In addressing the challenges of high energy consumption and low efficiency in fertilization borehole drilling for clayey soils in southern orchards, this study utilizes the Discrete Element Method to establish a simulation model for clayey soils. Through...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qi Liu, Juanmian Lei, Yong Yu and Jintao Yin
The bending deformation can affect the lateral force of spinning projectiles with large aspect ratios, thus interfering with their flight stability. Based on the established spin?deformation coupling motion model, the unsteady Reynolds averaged Navier?St...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhihong Wang, Chunguang Wang and Weiping Tian
In order to study the flow characteristics of a nozzle with large expansion ratio and its influence on the force on the nozzle, ground cold flow test research and a fluid?structure coupling simulation analysis were carried out (maximum expansion ratio e ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jintao Shi and Zhijiang Chen
This article develops three transverse rib setting schemes for a 20 m wide cantilever segmental box girder of a particular engineering bridge deck, analyzes the stress rules under loads such as dead load, live load, and temperature, and studies the later...
ver más
|
|
|
|
|
|
|
|
|
|
|
Lin Ke, Jinming Ye and Qiufeng Liang
Flow field performance tests of submarine models with cross-rudder and X-rudder stern control surfaces were conducted to study X-rudders? performance in non-uniform flow fields. The tests compared performance parameters such as resistance, lateral steeri...
ver más
|
|
|
|
|
|
|
|
|
|
|
Soo-Min Kim, Dae W. Kim and Moon K. Kwak
The membrane-type air spring can be used to suppress lateral vibration of a vibration isolation table. However, compared to voice coil actuators, pneumatic actuators are difficult to use for precise vibration control, because servo valves have nonlinear ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jin-Long Guo, Shuang Pan, Xiao Guo and Zheng-Yu Wu
The concrete-filled double steel tube (CFDST) has been more and more widely used in infrastructure due to its greater moment of inertia compared to the ordinary concrete-filled steel tube (CFST). With the increase in collision accidents occurring in rece...
ver más
|
|
|
|
|
|
|
|
|
|
|
Xiaohua Bao, Chunxun Liu, Lijuan Li, Jun Shen, Jihao Pan, Qijun Dong and Xiangsheng Chen
The Shenzhen Ma Wan area has special geotechnical conditions, with more than 50% of the area being reclaimed rock formations. Riprap reclamation strata are particularly susceptible to significant deformation upon stress release. To comprehensively compre...
ver más
|
|
|
|
|
|