|
|
|
|
|
Alessio Siciliano, Giulia Maria Curcio and Carlo Limonti
The pollution of water by nitrates represents an important environmental and health issue. The development of sustainable technologies that are able to efficiently remove this contaminant is a key challenge in the field of wastewater treatment. Chemical ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Munsu Kim, Lorena Perez-Andrade, Luke N. Brewer and Gregory W. Kubacki
This paper investigates the effect of the microstructure on the corrosion behavior of cold sprayed (CS) AA5083 compared to its wrought counterpart. It has been shown that the microstructure of CS aluminum alloys, such as AA2024, AA6061, and AA7075, affec...
ver más
|
|
|
|
|
|
|
|
|
|
|
Max Käding and Steffen Marx
Acoustic emission monitoring (AEM) has emerged as an effective technique for detecting wire breaks resulting from, e.g., stress corrosion cracking, and its application on prestressed concrete bridges is increasing. The success of this monitoring measure ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Henryk Kania and Anzelina Marek
Zn-Al-Mg-Si coatings are an excellent alternative to conventional hot-dip galvanizing coatings. Their high corrosion resistance in corrosive environments containing chlorides and CO2 is well recognized. But sulfur dioxide is also an important stimulator ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ji Qian, Peiyun Zhang, Yongqiang Wu, Ruixin Jia and Jipeng Yang
The corrosion of reinforced concrete (RC) is one of the most serious durability problems in civil engineering structures, and the corrosion detection of internal reinforcements is an important basis for structural durability assessment. In this paper, th...
ver más
|
|
|
|
|
|
|
|
|
|
|
Alexander Lange, Ronghua Xu, Max Kaeding, Steffen Marx and Joern Ostermann
Regular inspections of important civil infrastructures are mandatory to ensure structural safety and reliability. Until today, these inspections are primarily conducted manually, which has several deficiencies. In context of prestressed concrete structur...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zofia Szweda and Dominik Czachura
The consequences of the loss of the load-bearing capacity due to the corrosion of prestressing steel can be much more dangerous than in the case of reinforced concrete structures, since failure can occur quite rapidly and without warning. A very importan...
ver más
|
|
|
|
|
|
|
|
|
|
|
Qingli Ding, Hrishikesh Das, Piyush Upadhyay, Bryer C. Sousa, Kubra Karayagiz, Adam Powell and Brajendra Mishra
Friction stir welded (FSW) aluminum?magnesium lightweight vehicle joints have gained significant interest due to their high strength-to-weight ratio. In this work, the corrosion resistance of this material is analyzed through electrochemical tests, which...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jaehui Bang and Eunkyung Lee
In this study, the surface properties of marine structures were improved by applying a twin wire arc spray process to high-strength low alloys. The effect of Al and Mo contents in Ni-Al coatings on their mechanical and corrosion behaviors was analyzed us...
ver más
|
|
|
|
|
|
|
|
|
|
|
Mónica Echeverry-Rendón, Luisa F. Berrio, Sara M. Robledo, Jorge A. Calderón, Juan G. Castaño and Felix Echeverría
Magnesium (Mg) has been explored during the last few decades in the biomedical industry as a biodegradable implant. However, mechanical properties and corrosion resistance are still big concerns for clinical use. Therefore, this study proposes a suitable...
ver más
|
|
|
|
|
|