|
|
|
|
|
Emmistasega Subama, . Sepriyanto
Pág. 226 - 229
The influence of variationthe blade distance against the coco fiber and coco peat percentage of the coconut fruit from Jambi area has been done. The study aims to know the percentage of cocofiber and cocopeat produced based on the influence of variation ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Junjie Pan, Xin Lin, Zezhong Wang, Ruoyan Wang, Kun Wu, Jinhu Liang and Xilong Yu
This study investigated combustion characteristics of composite fuel grains designed based on a modular fuel unit strategy. The modular fuel unit comprised a periodical helical structure with nine acrylonitrile?butadiene?styrene helical blades. A paraffi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Alexander Hergt, Tobias Danninger, Joachim Klinner, Sebastian Grund, Manfred Beversdorff and Christian Werner-Spatz
In this paper, an experimental and numerical investigation of the effect of leading-edge erosion in transonic blades was performed. The measurements were carried out on a linear blade cascade in the Transonic Cascade Wind Tunnel of DLR in Cologne at two ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Zhiyuan Hu, Peng Yu, Guohua Xu, Yongjie Shi, Feng Gu and Aijun Zou
Tiltrotors permit aircrafts to operate vertically with lift, yet convert to ordinary forward flight with thrust. The challenge is to design a tiltrotor blade yielding maximum lift and thrust that converts smoothly without losing integrity or efficiency. ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Alessandro Capone, Francisco Alves Pereira and Fabio Di Felice
The design of super-cavitating propellers takes advantage of the development of air cavities on the blades? surface to reduce drag and, ultimately, increase efficiency. The mechanism of flow modification induced by the development of a cavity on the prop...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jie Zhang, Xiang Tian, Chao Zhao, Xiuzhen Yu, Shiguan An, Rui Guo and Bin Feng
During the steady operation of the 9FF square bale corn stalk pulverizer, the rapidly rotating spindle drives the hammers and impellers to form a complicated airflow field environment in the crushing chamber. The flow field characteristics in the crushin...
ver más
|
|
|
|
|
|
|
|
|
|
|
Catharina Moreira, Nikolai Herzog and Christian Breitsamter
Recent developments in electrical Vertical Take-off and Landing (eVTOL) vehicles show the need for a better understanding of transient aero-mechanical propeller loads for non-axial inflow conditions. The variety of vehicle configurations conceptualized w...
ver más
|
|
|
|
|
|
|
|
|
|
|
Weidong Cao, He Wang and Jian Tang
Guide vane submersible centrifugal pumps are a kind of submersible pump, and the fluid inside the pump is often mixed with gravel and other impurities during operation, affecting the pump?s operating efficiency and life expectancy. However, past studies ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Sen Deng, Weiqiang Zhao, Tianbao Huang, Ming Xia and Zhengwei Wang
Kaplan turbines are generally used in working conditions with a high flow and low head. These are a type of axial-flow hydro turbine that can adjust the opening of the guide vanes and blades simultaneously in order to achieve higher efficiency under a wi...
ver más
|
|
|
|
|
|
|
|
|
|
|
Shizhen Gao, Zhihua Fan, Jie Mao, Minhui Zheng and Junyi Yang
It is important to marine ecology research that plankton samples are collected without damage, especially for time series samples. Usually, most fixed-point plankton samplers are made using a pump with paddle blades in order to increase the flow rate. Bu...
ver más
|
|
|
|
|
|