|
|
|
|
|
Wenbin Zhang, Yan Feng, Xiangqiang Zeng, Ming Xu, Liang Gong and Lijun Rui
A new type of assembled integral multi-ribbed composite floor system with novel wet joint and steel sleeve connections, which exhibits satisfactory strength and stiffness, was proposed in the previous study. To further study the flexural performances of ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Jiaqi Hu, Yin Gu, Jinhuang Yan, Ying Sun and Xinyi Huang
With the convenient and fast requirements for construction in bridge engineering, prefabricated assembly technology is widely applied in engineering construction. Typically, prefabricated bridge decks are connected through cast-in-place wet joints. Wet j...
ver más
|
|
|
|
|
|
|
|
|
|
|
Kun Zhang, Pengbo Chang, Jianxi Ren, Zheng Liu and Ke Wang
The fractured rock mass in the western cold region is affected by freezing and thawing disasters and is prone to local damage and fracture along the fissures? ends. The fatigue damage induced by repeated frost heave and traffic loads seriously endangers ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Abdulnaser M. Alshoaibi and Abdullateef H. Bashiri
The objective of this study is to examine the behavior of fatigue crack growth (FCG) in the mixed mode (I/II) of the AISI 316 austenitic stainless steel alloy, considering mode mixity angles of 30°, 45°, and 60°. This particular alloy is widely used in t...
ver más
|
|
|
|
|
|
|
|
|
|
|
Chun Lin, Zhe Lin, Xin Xue, Song He and Lei Wang
Reinforced concrete (RC) structures under earthquake excitation may fail and cause significant casualties and economic losses, highlighting the importance of studying their seismic failure mechanisms. Considering that the commonly used finite element met...
ver más
|
|
|
|
|
|
|
|
|
|
|
Shu-Shan Li, Jin-Yan Zheng, Feng-Jian Zhang, Hong-Mei Li, Ming-Xiao Jia, Zu-Jun Liu, Ai-Jiu Chen and Wei Xie
On the basis of the test results of nine steel-fiber high-strength concrete corbel specimens subjected to a vertical load, the influence of the steel fiber content on the shear performance of corbels was analyzed. The softened strut-and-tie model (SSTM) ...
ver más
|
|
|
|
|
|
|
|
|
|
|
Ta Quy Hung, Mitsuo Mizoguchi and Yuya Takase
Every year, Vietnam faces typhoons accompanied by strong winds. Semi-permanent houses are severely damaged by these winds. We researched a strengthening method using a Polypropylen (PP) band to prevent housing damage caused by strong winds. In this study...
ver más
|
|
|
|
|
|
|
|
|
|
|
Yuan Tian, Bangcheng Han, Xinyu Liu, Kai Shen and Jiangbo Li
Using experimental methods to study the influence of hole and cracks on the mechanical properties and fracture characteristics of rock-like mortar materials under biaxial compression conditions. The double crack specimens with hole depths from 0?100 mm a...
ver más
|
|
|
|
|
|
|
|
|
|
|
George Xiroudakis, George Saratsis and Ilias Lazos
This paper uses the displacement discontinuity method, one of the boundary element methods, to solve two major engineering problems. The first one addresses the safe design of underground excavations in fractured rock masses. The implemented method was u...
ver más
|
|
|
|
|
|
|
|
|
|
|
Wansen Guo, Jinshen Wang, Chao Shi, Jianhong Chen, Wenhui Zeng, Guoxiao He and Kunying Ding
On the aero-engine combustor liner, a phenomenon of overheating resembling a hot spot exists, accompanied by a preferential peeling of the YSZ thermal barrier coating that will negatively affect the service life of the component. The hot spot temperature...
ver más
|
|
|
|
|
|